What 5ch or 3/2 to match Aragon 8008bb?


Hi everyone, I'm hoping to solicit your advice; I'm having a hard time finding any answers to this question.

I'm picking up an 8008bb Aragon for my mains, but i'm running a 7.1 system, and need to get amplification that will match well with the 'bb'.

Any suggestions? I've heard the acurus a200x5 is voiced similarly; and I've thought an 8008x3 for the center and 2 side surrounds, with a cheap amp for the rear surrounds might work as well...

I'd like to keep it around $2k total if I can, but I'm not sure if that's possible.

Thanks for any advice you can give!

-Kincade
kincade
Hi Kincade:

DO NOT leave your Aragon amps on all the time. I don't know if anyone else can attest to the same sort of experience, but I didn't pay much attention when I first had my 8002, so I left it on all the time. Aragon amps tend to be havily biased into class A, and I didn't realize my little 8002 drew 1000watts just sitting there doing nothing. My first $400 electric bill(for ONE month)
stopped me from doing that. Besides, they only need about 10-20 minutes to warm up and sound their best anyways.
By the way, all "Class A" amps switch to class A/B when putting out more than several watts(varies a bit). The reason the 8002 and 8008 pull so much idle current is because they are heavily biased into A, which is very inefficient, but switch to class A/B probably when output exceeds around 10-20 watts. I can explain more if you wish to be bored to tears sometime. Oh, and I have had a
Sherbourne 5/1500 connected to my JM Labs Electra 936 speakers a while back, and it was ok. Haven't heard the one you have, but the one I heard simply couldn't keep up with my 8002, let alone my 8008BB. Frequency extremes were where the Sherbourne seemed a little lacking. Still, if your only going to use it for non-critical listening, it would be good for a hometheater. I'm also a fussy pain-in-the-butt 2-channel snob, so take my advice with a grain of salt. Using the Sherbourne for the surrounds? Probably should stick with it and save some cash. $1200 buys a lot of movies! Whatever you decide, good luck, and ENJOY...

Shayne.
Hi Kincade
Shut them off when your done. no doubt. Saves elec. and saves the amp. seems like you're getting alot of thoughts now. that's always a good thing. best of luck.
P
Shayner and Oldpet,

Thanks for the power advice! I'd hate to hear the complaints when we got stuck with a $400 power bill, LOL.

Shayner; the 5/1500 was a full class A/B, but the new 7/2100 are A/G; they say they switch to G at higher loads, just like the others, but I don't know at what point... I think it's an OK amp, but I really hate to buy one and 6 months later wish that I had bought the Aragon. 'Course, some people say that the aragons are too bright... Maybe i'd hate both.

To date, i'm not happy with the bass and treble; I want good frequency extension (without being too analytical or bright), and low/tight/and controlled bass.

Keep the opinions coming! I sincerely appreciate all of it to date!
Kincade,

I was not able to do a direct comparison between the Sherbourn and The 8008BB, but I was able to compare the BB to a pair of NHT A1 monos that are basically identical to one channel of the Sherbourn. I'd say that the BB has more authority in the bass. I prefer the top on the Sherbourn. I've always thought that the Acurus stuff was really brittle and I've read here many times that the BB can get hard when pushed hard (top end) which I agree with. The Sherbourn will run out of steam before the BB; it doesn't get bright or clip it just won't go any louder. However, you can bridge two channels of the Sherbourn and compensate.
So, I liked the way the BB grabs a hold of the bass and manhandles it. It's a tough call for me - do I want the better bass with the very slightly forward top end or do I want slightly less bass and a better top end? I guess it comes down to personal preference.

At one time I had the BB doing the mains, the 4004MII on the center, and the NHT's and a SAR labs mos400 doing surrounds. And, I had a pair of palladiums in the system for a short time. It was a nightmare with all the expensive power cords and power conditioners. So, I sold everything (expect the palladiums - on loan from a friend) including most of the PC's, purchased the Sherbourn and put some money in my pocket. What I really like about the Sherbourn is the 12v trigger.

My system is used 80% for two channel music and 20% for movies/HD programming. Right now it sounds oh soooo seductive with the Xindak SACD2 and the Soliloquy 5.3I's. There is a direct correlation between how good my system sounds and the number of books/periodicals I read. For the last few years the coffee table had been devoid of reading material; lately it's been covered.

So, if money was not an issue, I would say use a BB on the mains and let the Sherbourn do the rest of the system. However, I'm quite happy letting the Sherbourn do all the duties.

Hope this helps,

PS - Music taste is pretty much anything but rap and Britney. And, I like my system to sound laid back. Also, I'm not a bass junkie.
So you think the top end is forward? I've always read that the Aragon 8008's are very neutral, but can sound bright with the wrong combination of speakers and equipment.

I've also heard that the 8008 can make bad recordings sound bad; which indicates to me that it is very neutral, and is not adding or taking anything away from the source; which I consider a good trait.

Either way i'm gonna have 2 cords; but the 12v trigger IS nice, as opposed to manually turning it on and off.

I don't understand your comment about the reading material... Perhaps I'm slow today!

My musical taste is very similar; from metal to indie, to country, to singer-songwriter. I HAVE to listen to music often, as it's part of my business. So i'd like it to be as enjoyable as possible.