How to equalize a bi-amplification setup?


Greetings!

Any one experienced in bi-amplification setups with different amplifiers, where output must be equalized?

In my bi-amp setup I use one pre-amplifier connected two different amplifiers, via balanced and unbalanced connection, feeding a pair of 2-ways loudspeakers (Pass Aleph P, Pass Aleph 3 on tweeter and Pass Aleph 0s on woofer).

Problem is the Aleph 0s results in a final higher sound volume (at least +3dB). Theorically I think this should not happen as manual gain of both amplifiers indicate a +20dB gain, altough the Aleph 0s outputs much more current.

How can I "calm down" the bass amp without comprimising the sound quality and without opening the loudspeaker to introduce one attenuation circuit?
sony
An easier solution:

Whatever interconnects you are using, contact the company and they can make you a balanced Y splitter so that the output of the amps will be the same. Feeding both amps balanced will probably also give you better sound.

Richard
Herman, that's right - only the Aleph 0s has balanced inputs.

Drrdiamond, could I extract the signal of the balanced output of the preamplifier and split it into a balanced and unbalanced connection? (one XLR to one XLR and one RCA)

Another reason for doing so is that I will have more power in the end than attenuating the signal to the bass amplifier.

Cadet1, I must say that my bass section is not a sub-bass one (200Hz), since it will be handling frequencies up to 2.5KHz, so there's a lot of midrange there. Couldn't the eq spoil it a bit?
sony,
Personally, I'd be uneasy about going up that high. In my present system the signal is only EQ'd below 100Hz.Something like EVS attenuators would probably work better for this application,I used to have a pair of these and they work extremely well. Only one series resistor in the signal path and one shunting to ground.