Microphonic Amps?

Hi Gaffer,

A tube that is exhibiting a microphonic condition adds an unwanted contribution to the signal flowing through the component. The microphonic signal added to the original signal takes us further away from faithfully reproducing the instrument that has been captured in the recording.

A tubed component that is subjected to floor-borne vibration that is entering through the equipment support can cause tube microphonics. In addition, air-borne vibration that is striking the component's chassis as well as internally-generated vibration (transformers) may also be contributing. Isolating the component from the floor-borne vibration and restricting the other two forms of vibration as much as possible will minimize the problem of microphonics.

Some vibration control products allow the component to resonate freely or do not restrict the air-borne or internally generated vibration from affecting the component. This allows the signal to become contaminated. Once that occurs it will be impossible to restore the signal to its original, unaltered condition.

Best Regards,

Barry Kohan

Disclaimer: I am a manufacturer of vibration control products.

Thanx for that everyone (nicely explained :-) )
In that case, do I take as much care as with turntable placement....would an anti-resonance base help or would tube rings be a better bet re: next purchase?

PS, my amp is integrated, with the pre-amp section being 4 small GEC valves, and the power amp section being 4 large Svetlana EL34 valves:
http://www.affordablevalvecompany.co.uk/

Well, you'll get no answer to your question that everyone will agree on. For small tubes in my amps I have found it easiest, and most effective, to buy tested low noise tubes in the first place on which I place those inexpensive rubber damping rings. Then I try to reduce exposure from floorborne vibrations by using a combination (sandwich) of materiels with different resonance frequencies to absorb the vibrations (a DIY project). Some times I use cones (or not) to couple the component depending on the effect it makes. I do not try to couple the rack itself to the floor (except for stability) as I feel the combo of materiels used under the component are sufficient, besides I have wood floors and I think coupling might just enhance floorborne vibrations effects on the components. JMHO. Good luck getting any consensus.

Gaffer74...Think about it...a phono pickup is designed expressly to pick up small vibrations, whereas tubes are designed to minimize microphonics.

Turntable vibration control is essential although IMHO it calls for common sense more than expensive equipment. Amp isolation is something you can play around with when all the significant problems of your system are solved.

Thanx everyone.
My system currently sounds fantastic, and I cannot really find significant probs...but would just like to optimize anything that can be (if that makes any sense).
I have my system in a particularly bass heavy corner of the room on a steel glass stand with halved squash balls under each foot to try to minimize vibrations further.
Again..I can't hear any odd/problem areas as such, but just wanted to get the best in the area I have the equipment currently.
Thanx for all your input....I think I'll spend further dosh on music instead ;-) as I feel I have it isolated as much as i can, and it sounds great.