Question on preamp matching with Wright 3.5 2A3 am

Wright's own preamps match up brilliantly with his amps. The WPL12 would be a great match-up if you don't need a phono stage or his AU1000 (dealer-only) if you can find one. I've owned the 3.5's and have heard many of George's products (great stuff and a reasonable price). The lower output pre would simply necessitate your cranking the volume a bit more. The absolute quality of the sound is another matter entirely and is not necessarily related to a precise matching of output/input within .5V. If it is really far off I suppose it may bring in some noise and distortion.

Marco

I know about the Wright but it has no remote. I got the pre yesterday, Rogue, and I cant get my current speakers to play any louder than low conversation type volume. They are B& W DM601's 88 db effec. I have to turn up the volume to over 75% to get even this low little bit of sound volume. Based on what I have been reading this is not right. I know the Cain & Cain is 96db effec, but I am concerned my amp/pre combo wont work.

I use the Ack Dack which is rated for 2V peak to peak for 1 KHz 0db signal. I just think I should have had more volume on these 88 db speakers. I know it would not drive them loud, but the max volume level I got was very low.

Bill

Bill,
That low volume you're currently getting is due to running 3.5 watt amps into 88db speakers, not a mismatch between amp and preamp. Once you get those 96db speakers things should improve dramatically, at that point start trying different pre's. I agree with Marco about trying a Wright pre, if you can live without remote. Otherwise your Rogue might be just fine.

Absolutely, as Jond says, the primary reason for the limited volume is the
mismatch of a low-efficency speaker with a flea-powered amplifier. I could
never drive my 89db efficeint SR17 monitors beyond very low volumes
without alot of distorition with my 3.5's. The Cain&Cain is certainly efficient
enough for a good match. I have not heard them myself, but they sure are
beautiful to look at, and the Voight pipe design they are based upon is a
standard in the single-driver world. Be aware, you are going into a whole
other direction that your what you are used to with your B&K and whatever
you were driving them with before. You may want to make sure it is just what
you want before dropping $1500 on a new pair of very large speakers. There
are other choices in the more 'conventional' monitor/multi-driver speaker
you are used to that may work nicely with the 3.5's. I'm into the older Klipsch
horns myself, which are also quite large and do not sound like conventional
speakers. In the realm of what you are used to there are the Reference
DeCapo 3a's which can be had used for the price of a pair of Abby's. Look for
something with at least a 96db efficiency if you want to play music at more
realistic volumes with the 3.5's. Do a search here and on AudioAsylum
(perhaps in the high-efficiency speaker asylum) of your amplifers and see
what others are using. You should certainly be able to use your Rogue at that
point, but I'd still recommend a Wright pre for great synergy.

Be aware also that those 3.5 amps are all about midrange. When set up well,
they will yield of the most stunning midrange reproduction you are likely to
hear from amps of that price. However, in my experience, they do not do
bass well if you have expectations around more conventional push/pull
designs. So if you do have such expectations, and are a big fan of low bass,
I'd definitely seek out a speaker that is known for it's ability to reproduce
lower registers well. If you are a bass freak you may even end up considering
a sub. Of course, if midrange is all you need than you sure came to the right
place!

Marco