Just reviving this old thread as I have found what for me is the best regulator tube I have heard in my Supratek Chenin, that being the Valve Art 350B. I know there have been posts from others extolling the virtues of the WE 350B but that is SUPER Pricey! The Valve Art is $34.50 per matched pair from AES, and works great!
The sound is very open and spacious, with excellent bass (comparable to or even a bit better than the Sovtek KT66 I had been using) and an enormous soundstage. The difference was not subtle versus the Sovtek KT-66. So in my experimentation so far, I've found:
VA 350B > Sovtek KT-66 > NOS Tungsol 5881 > Sovtek 5881
Before I did the swap I did some reading about shunt regulators and found some articles stating that the higher the transconductance, the better the tube is as a shunt regulator. Although I could find no specs specifically for the Valve Art 350B, the WE version lists a transconductance of 8300 mho, versus 6300 for a KT-66, 5300 for a 5881, and 4700 for a 6l6GC. Based on that difference I gave it a try.
I did contact Mick to be sure the higher filament draw wasn't a problem and he said it was fine, so I don't think that's a worry - so far ~20 hours and no issues. I fine tuned the B+ voltage to remain at 300V after switching tubes (it was very close anyway) so the differences are not due to a change in operating point of the other tubes.
Just thought I'd share.
The sound is very open and spacious, with excellent bass (comparable to or even a bit better than the Sovtek KT66 I had been using) and an enormous soundstage. The difference was not subtle versus the Sovtek KT-66. So in my experimentation so far, I've found:
VA 350B > Sovtek KT-66 > NOS Tungsol 5881 > Sovtek 5881
Before I did the swap I did some reading about shunt regulators and found some articles stating that the higher the transconductance, the better the tube is as a shunt regulator. Although I could find no specs specifically for the Valve Art 350B, the WE version lists a transconductance of 8300 mho, versus 6300 for a KT-66, 5300 for a 5881, and 4700 for a 6l6GC. Based on that difference I gave it a try.
I did contact Mick to be sure the higher filament draw wasn't a problem and he said it was fine, so I don't think that's a worry - so far ~20 hours and no issues. I fine tuned the B+ voltage to remain at 300V after switching tubes (it was very close anyway) so the differences are not due to a change in operating point of the other tubes.
Just thought I'd share.