Tubes? Transistors? Which are better?

Try Jeff Rowland with Michael Green Designs Chameleon loudspeakers,Albert.Tell me later if it is not convincing.

I have heard Jeff Rowland's amps, and for transistors they are one of the three best I have ever heard. The others being Griphon from Sweden, and FM Acoustics from Switzerland. I still prefer tubes, for the same reason I stated before. It after all, is a matter of choice, and I certainly understand why you like what you do.

I feel as many (most?) reviewers do: That tube amps emphasizing even order harmonics (that are "consonant" with the music) doesn't BEGIN to explain the positive aspects of a tube amp...BECAUSE most all tube amplifiers DON'T JUST have higher even order harmonic distortion; they have MORE of BOTH ODD AND EVEN order harmonic distortion (than do ss amps, usually). And no, TRANSISTORS DON'T SWITCH (completely) ON AND OFF, and don't do it at all in a class A circuit. Any class AB circuit's output devices will switch on/off to some degree, WHETHER IT'S TUBE OR SOLID STATE. One should not dismiss ALL solid state amps until one has heard them all in one's system. I think the flaws with solid state (when they exist) have more to do with what a higher (than a tube amp's) slewing rate does when it's not controlled well enough. IT OVERSHOOTS THE SIGNAL, etching a false "glare"/"grain" onto the resulting waveform. This is evident when a square wave test is done, when you can see obvious overshoot. Most tube amps round off the corners of a square wave, lending a more "rounded" quality to the music. ALSO, all these guys touting the Sony SCD-1 need to realize that it doesn't even have a discrete output stage...it has op-amps!!! My CD50 has HUGE BIPOLAR OUTPUT DEVICES THAT RUN IN CLASS A, so it can easily mop up the floor with an SCD-1 when playing CD's "only"...besides the fact that it doesn't need a linestage, and that it's output stage is "beefier" than many stand alone linestage's outputs...

Elizabeth I would agree that a tube amplifier is higher maintenance and can get pricey when replacing tubes but a tube pre-amp is another matter. The tubes will last for a very long time, even when left on providing you go with the right design. I have owned 5 different tube pre-amplifiers over the last 15 years with VERY minimal problems. Yes I have had to replace caps but that is to be expected over a period of time. I suggest you listen to a good tube pre-amp (ARC are very reliable and well engineered)before you go out and buy an Adcom 750. A tube pre-amp is MUCH more like music. Try before you buy and then decide. Good solid state pre-amps cost bucks. The cheaper designs don't fare as well against their less expensive tube counterparts IMO.