Replacing internal wiring.


For all those people spending big bucks on speakers cables , ever check into replacing the internal wiring in speakers or the amps?

Most but not all have cheap wiring inside, and does not even compare to whats on the outside, I was thinking about rewiring my speakers, with some kimber or audioquest using WBT solder thoughout.

Also doing the same operation on the amps, inside the amp is just a matter of replaceing some 12" jumper spades that would be super easy compared to the speaker over haul.

Let me know what you think
infwgf
The idea is OK, but the length of the wire inside the amplifier and speaker is generally much shorter than that of the speaker cables, and so I would expect that it is less critical to have such high quality wire inside the amp and speakers. It should make a difference, but I would expect the difference to be much less marked than upgrading the speaker cable itself. These reasons have always put me off doing any such mods.
Sean, i recently re-wired a pair of mono-blocks. In the process, i was able to re-route the wiring for a MUCH shorter and cleaner path. As i've said before, if some of the EE's designing audio gear were doing RF gear, we'd still be using tin cans and string. Some of the stuff that they do just doesn't make sense, especially when talking about NON "mass-produced" hand built stuff.

Putting all of the various "snippets" together end to end, i was able to take out almost 4 foot of wire out of each amp. This probably gave me at least another 100 wpc due to the reduction of series resistance*. Sean
>

* PS.... I'm just joking. You get the point though : )

Well inside my amps, they use the insulated spade connectors, and all I would have to do is remake some new jumbers and presto, it would be done.
Soldering is not heating and applying the stuff , there has to be a cleaning process and proper priming if needed to be succesfull