Darn it, I scratched my Roland Now what

The response by Abstract7 was good -- you could also use some jeweler's rouge as a buffing compound (the kind used on buffing wheels). Rub some rouge on a soft, damp cloth and apply. When the scratch is reduced to an acceptable point, some liquid car polish on the entire top plate should complete the job.

jeff rowland's products are anodized rather than painted. in my experience, products designed to deal with painted surfaces do not work very well on anodized surfaces and can, in fact, cause greater harm than good. i've had the same problems with scratches/scuffs; i've been able to correct them, i'm sorry to say, only by obtaining replacement parts. can't hurt to try abstact7's solution, of course, but do test on the underside of your piece first. good luck. i hate it when that happens! -kelly

Cover it with a VPI brick or a Shakti stone.

Gare what a bummer: sorry to hear about that, but it happens to most of us sooner or later. If you must try a compound: get POLISHING compound not rubbing compound. Some times a black permanent marker (Sharpie ultra fine tip) or a Marks-a-lot can be used to to fine-touchup small injuries on black surfaces

Dude, you could just chill out. that's my advice. no offense at all because we've all been there but sometimes we all need to chill about this stuff. and sometimes we need someone to remind us. in this case it's me. chill, bruthah.