Replacement pwr supply for Aragon 24k

Thanks again for all your replies. Steve at Klipsch asked about a fuse but I don't see one anywhere. He even looked at a schematic while I had him on the phone and he could not locate one either. Satch thanks for the link but it looks like the upgraded ips. I have the standard version which should be simpler. Spiro the Krell may be my next recourse if I can't find a ps. Stay tuned

Do you have the IPS or the standard, rectangular power supply?

Either way, my suggestion is to have it repaired.

I have the standard. Hope I can obtain a new one or as you suggested have it repaired.

I have a 47K phono stage with a stock power supply. I'm looking to upgrade the sps to something like the IPS but they are discontinued. Does anyone here know if we can use something like this...

http://cgi.ebay.com/MASTECH-VARIABLE-REGULATED-DC-POWER-SUPPLY-0-30V-0-20A_W0QQitemZ120115288628QQihZ002QQcategoryZ32720QQrdZ1QQcmdZViewItem

It's a Variable Regulated Power Supply intended for Laboratory use. Can be set to the desire 24VDC and over 250ma. What I'm not sure of is if the requiered +24vdc, - 24vdc can be fulfilled by adapting the cable to the + and - plus Ground into the 3-pin connector which goes to the 47K/24K units. ( I'm guessing so excuse me...).

Jahaira

PS: camino3x2 I sent you an email through another site where you reviewed the Aragon gear...thanks!

Hi!
The power supply for my Aragon 24K Pre-amp just went out. You say there is a fuse? If so, where is it and how do you open the power box? Thank you for any assistance you can give me.
Penonome