Replacement pwr supply for Aragon 24k


Looks like the ips gave up and I'm now in need of a replacement. The pwr supply is the standard piece that comes with this pre although the updated ips would work. Pity Mondial is out of business. Thanks and enjoy the music.
south43
I have a 47K phono stage with a stock power supply. I'm looking to upgrade the sps to something like the IPS but they are discontinued. Does anyone here know if we can use something like this...

http://cgi.ebay.com/MASTECH-VARIABLE-REGULATED-DC-POWER-SUPPLY-0-30V-0-20A_W0QQitemZ120115288628QQihZ002QQcategoryZ32720QQrdZ1QQcmdZViewItem

It's a Variable Regulated Power Supply intended for Laboratory use. Can be set to the desire 24VDC and over 250ma. What I'm not sure of is if the requiered +24vdc, - 24vdc can be fulfilled by adapting the cable to the + and - plus Ground into the 3-pin connector which goes to the 47K/24K units. ( I'm guessing so excuse me...).

Jahaira

PS: camino3x2 I sent you an email through another site where you reviewed the Aragon gear...thanks!
Hi!
The power supply for my Aragon 24K Pre-amp just went out. You say there is a fuse? If so, where is it and how do you open the power box? Thank you for any assistance you can give me.
Penonome
@ Penonome: the screws are in the rubber thingies at the underside of the powersupply. Unscrew them and you can slide the triangular top of. Then you should see this (click link):

http://aycu06.webshots.com/image/29405/2001951001830719888_rs.jpg

The fuse is on the right. Good luck!
Thanks Satch!

I must have a very old Aragon 24k because the power box is not triangular and, after removing the rubber thingies on the underside there was nothing to unscrew. It is solid with no indication of a place to open it. I wonder if I have to pry open the box. The model number is ILDK-19 if that means anything.

Again, thanks for your kind help.
Penonome
Aha. I have the Aragon 24K with the IPS, the Improved Power Supply. This wasn't standard, you had to buy it separately. It was said to improve upon the standard powersupply, which you probably have. I have seen thatone in real life, so I can't tell you how to open it. But I'm sure there's a way to open it, and I'm also sure there's a fuse inside. There is an entire forum dedicated to Aragon gear, so you might ask your question there:
http://forums.klipsch.com/forums/20/ShowForum.aspx