2. misc-audio
  3. 1045147252

Digital isolation. Am I doing this correctly?

I used to have my amp and my cdp plugged into my Audio Magic Stealth. Cdp in one outlet (left side) and amp in outlet on the right. Since purchasing my Stealth, last year, Audio Magic came out with a Mini Digital. I have purchased the Mini Digital and the (they are on the way) new Matrix. Now I will be able to isolate these babies properly. Does it matter if they are both plugged into the same wall duplex outlet? Will I achieve the isolation I want, or should I plug one of them into a different outlet? Thanks in advance. peace, warren

P.S. review to come, of course, after I burn these babies in. Takes a good 300+ hours. I do them apart from my system with some high amperage (vacuum when I'm away, space heater when I'm home) stuff, to really get them cooked, quickly. I will keep you posted.
128x128warrenh
onhwy61's avatar
onhwy61
5,248 posts
 
Just be sure to spend plenty of hours dissecting the sound of your revised system setup. Try not to let the music get in your way.
theaudiotweak
2,801 posts
 
Warren, you may have some loss of absolute benefit by using the same common outlet.. In theory and probably also in practice you would be better all the way around to have two duplex outlets each with their own dedicated supply and each with their own respective isolated ground.. Tom

stehno
1,453 posts
 
Warren, some line conditioner are better at bi-directional line conditioning than others and often times will state so in their literature. Filtering the noise going to the component and back out into the line.

Whereas others are absolutely one way only. And of course the line conditioner allows the digital noise to get back into the line to share with other components on that line.

Even if your line conditioner is bi-directional, you're probably better off to plug the digital source into a non-audio line with your digital line conditioner.

As to the grounding issue. I'm not grounding any of my components. To minimize ground loop problems, I would think you'd want all of your components to share the same common and isolated ground.

Correct me if I'm wrong.

-IMO
adsal7e18
250 posts
 
i think, digital model should be plugged to matrix
More to discover