2. misc-audio
  3. 1055346207

Aurios vs Stillpoints, any experience?

I have a set of Aurios 1.1 under the feet of my Sota Star Sapphire turntable, and have been very happy with the results.

Recently I had the opportunity to audition a set of the Stillpoints. I am concerned about the fact that there is unlimited travel with the Stillpoints so theoretically it is possible for a piece of electronics to roll off of the bearings. I wanted to use the Stillpoints under the TT but because of the amount of motion involved with the TT I am worried about the TT falling. Between opening and closing the dustcover, swinging the arm, and removing LPs I am worried about possible damage.

I installed the Stillpoints under my amp and it has not moved at all, but the amp is close to the floor, and is moved much less than the turntable.

Does anyone have any experience with these bearings and how did the compare to one another??? Is it possible for equipment to roll off of or around a level shelf??? Are these valid concerns???
128x128nrchy
gilas
39 posts
 
Yes, Norm. You're right - it is partly the points settling into the shelf. If you look carefully at the points of contact, there are signs of pressure induced depressions.

However, I tried some titanium cones w/o the Neuance shelf elsewhere. Was warned that the cones will take a few days to settle in. Of course, did not believe it. Had to eat my words when that settling in effect was observed.

So, I think there are some happenings I do not understand fully and cannot explain with logic.

Tom
tbg
5,263 posts
 
I really cannot understand titanium cones settling in, but you can certainly disrupt the cables, shelf, and even the component in installing such cones. I think it takes about two hours for cables that are moved to recover. I know I will probably get a response to this.

The last several days I have been experimenting with Audio Prism QuietLine filters. Initially one in the duplex where my system is plugged helped. I got more QLs and installed them mainly in my listening room, whereever the Noise Sniffered found a problem. The music lost all realism and pace.

On Jim Weil's advice, I put two quite distant from my system, and this gave a nice improvement in lowered noise. All of this is contrary to what Audio Prism said about how to install. I imagine there is some physical explanation for it, but I do not know what it might be.
gilas
39 posts
 
Yeap, the X-files ....

Norm, of topic question. Do you have any experience with parametric EQ in the bass, mid-bass region ? Would like to compare notes if you have. You can sent me a private e-mail.

Thanks,

Tom
More to discover