World's best Pre-amp for $10K and above?


Looking for the HOLY GRAIL in Audio? Here it is. I'm in my early sixties and retiring to my final system, which I was going to purchase during the past twelve months and decided to put on the brakes, and investigate whats out there as the most advanced engineered high end audio products for the money in the market place. As far as I'm concerned, the two top engineers in the world for the best Amp and Preamp at low prices are Bent Holter with Hegel Audio in Norway and Roger Sanders with Sanders Sound in Colorado. Why? The Hegel P-30 Pre-amp is a game changer, and will easily compete with Pre-amps at $30K and above. The FM Acoustics 268 Preamp that retails for $107K, uses a technology thats called "feedforward" instead of feedback.
Amps and Pre-amps since the early 80's have all used either global feedback, zero feedback or local feedback to filter out noise and lower distortion by sending and filtering the feedback current to filter capacitors or or an extra filter transformer. A small amount of voltage feedback occurs at the output stage in amps and preamps which goes back into the parts and boards causing noise and distortion which smears the quality of the music.The best Preamps in the world all have S/N noise ratios at 125 db's or above. The Hegel P-30 Preamp uses the same feedforward technology as FM Acoustics but is a more current design that Bent Holter calls "Sound Engine" patented technology that eliminates feedback which is why the P-30 Preamp has a S/N ratio of 132 db's, which has never been accomplished in high end audio with a Preamp costing $10K or below. The same applies to Roger Sanders Magtech amplifier which uses a patented linear voltage regulator that controls and regulates voltage with no excess voltage going back into the amp causing heat and distortion problems. The amp puts out 900 watts into 4ohms. Krell makes a pair of mono blocs that also use a similar voltage regulator. The amps are $100K a pair. HERES THE PERFECT SOLID STATE SYSTEM. A Hegel P-30 Preamp. A Sanders Magtech amp, A pair of Aerial Acoustics 7T speakers. The worlds finest SACD player, the Playback Designs MPS-5, designed by Andreas Koch, who invented SACD technology when he worked for Sony. He built the worlds first outboard DAC in 1982 and is legend in digital engineering. The MPS-5 is the most analog sounding player on the market which costs $17K. The Hegel P-30 is only $7500.00 and the Magtech amp is only $5K. The Aerials are $10K. Buy the solid core cables from Morrow Audio. They are low capacitance cables which matches up perfectly with these components. This combination sounds like the very best tube and solid state gear on the market. The whole system will cost about $42K but will sound as good as any system costing $200K. All of these products are game changers. If you want better looking cabinets and faceplates, then blow your money, but you will not get better performance for what this system has to offer. It is the HOLY GRAIL you are searching for and there is no better combination for the total cost of the system.
audiozen
Peterayer,
Nice post and very good observations.Atmasphere you may not accept the term "voicing" but I find it hard to believe you or anyone can absolutely be sure of the sound of a part or component based 'exclusively' on measurements and specifications(your Vcap example). It seems listening is required at some point to confirm/verify the expectations. Atmasphere I`ll assume you listen to your finished products or is this a wrong assumption? If measurements and specs are that dependable then Audiozen is right with his reliance on stated figures.Is`nt the building of audio components a mixture of engineering, science and art?
Regards,
You might engineer a plane but it still has to be test flown. Yes, we do a lot of listening. Human hearing rules are not well accepted in the audio industry (how's that for a conundrum) so test equipment does not tell you everything.
Audiozen, when are YOU buying YOUR system? It has been some time since you sold yours. This time AGAIN, you're saying this one is the best. Show us by YOUR OWN actions, not just words.

We are still waiting for your move.... What do you have to lose? You have all kinds of connections, and inside information, according to what you say. You've had numerous personals contacts with these companies. It's time!
I do not just rely on specs to determine the musical
quality of an Amp or Preamp. If that were the case, I'd buy my separates through a mail order catalog without listening. The point I made is that the most expensive and most musical separates globally that sell in the $15K to $100K range, brands that are well recognized and have outstanding international reviews for years, all have specs that are in common with each other. Higher S/N ratio's, ultra low distortion, and wider bandwidth's and higher damping factor's. Its not that these audio engineers at these companies try to get the highest spec numbers first before listening, but just the opposite. They all strive to design products with the lowest noise and distortion possible to keep the music signal as pure as possible without any disturbance to the musical signal. By achieving this goal will always result in specs with very high numbers due to superior design engineering.