2. speakers
  3. 1133903740

Zu Tone/Druid Tonal Anomalies

I like to hear anyone with Zu speakers if they have had a similar problem. I recently acquired a pair of Zu Tone speakers. Certain aspects about them are very good, such as soundstaging and speed, but it seems to me that unless my pair are defective, there is a serious issue with tonal accuracy. Right away when I set them up, I noticed that they sounded quite hollow. I then made a lot of measurements, both close miked and at the listening seat, with both a Behringer DEQ2496 and an RS sound level meter (using both pink noise and frequency generation). In both cases, it fairly closely matches what I am hearing, which is a severe rise in the upper midrange. I am trying to use a Z-Systems RDQ-1 digital EQ device to correct this problem, and have gotten much closer to a natural tone and flatter curve. What this required was a 7.6 db cut centered at 1.4kHz at a width of 1.5 octaves. This is quite a cut! For reference, I've had two other sets of speakers (Monitor Audio GR60 and NHT ST-4) in the room at almost exactly the same position, neither of which had this problem. I spoke to Sean Casey at Zu about the problem, and he thought it might be room interaction, which might be true to a point, but the anomaly is just too severe, and makes this point less viable since my other speakers didn't show the problem. I noticed in another thread here, that a couple of people heard what seemed like a similar problem with the Druids.

I am very curious as to what others have experienced with any of the Zu speakers in this regard.

Thanks,
Stew
smeyers
213cobra
885 posts
 
A brand new pair of Tones will honk or shout some until broken in. My Druids did the same thing. My Definitions less so. Room interaction can exaggerate this. The rise you are hearing, insofar as it is driver-generated, will mitigate with break-in day-by-day until you hear them settle into a natural response. At least that's my experience. Room interaction definitely affects the degree to which you experience this phenomenon.

Also position. The speaker is smoother even new on a stout pair of stands. The Tones are also more sensitive to room effects than the Druids and much more so than the Definitions.

How much use have your Tones been subjected to?

Phil
matrix
305 posts
 
Yeah the definitions are pretty much drop in place and play, less issues with positioning and height and all that vs. the other 2, so I guess let her rip for a couple weeks and hope it starts to straighten out. However, I would remove the eq while breaking in so that they just do there thing and get all natural signal to smooth out.
pjl2122
83 posts
 
my response to the tone and druids is fact.
I own both .If you are considering these loudspeakers have the factory put 150 hours on these for you first.
There drivers are so stiff that unless you are playing these guys with a low 30 hz breakin cd on repeat for at least 150hours the cone does not even move,or you have to jam these at over 100db, just in breakin,at the factory they play them at over 110 db ,seriously. and infact would not fully break in unless you do.I know I spent 300 hours learning.
point 2. the druids Must have the short spikes unless you have very thick carpeting,a little more than a cd s width under the speaker is all that you want to load this bass ,for good integration of all aspects from the mids on down,again I experimented for several hundred hours ,even after the 300 hour period.
now everyone that comes over is dam impressed.
No loudspeaker at anywhere near this price point does so many things so well, when set up ,and run in properly Paul J Letteri.
pjl2122
83 posts
 
my response to the tone and druids is fact.
I own both .If you are considering these loudspeakers have the factory put 150 hours on these for you first.
There drivers are so stiff that unless you are playing these guys with a low 30 hz breakin cd on repeat for at least 150hours the cone does not even move and infact would not fully break in.I know I spent 300 hours learning.
point 2. the druids Must have the short spikes unless you have very thick carpeting,a little more than a cd s width under the speaker is all that you want to load this bass ,for good integrationagain I experimnte for several hundred hours ,even after the 300 hour period.
now everyone that comes over is dam impressed.
No loudspeaker at anywhere near this price point does so many things so well .
pjl2122
83 posts
 
hello I hear a fair amount of people talking about speaker interactions wit thw zu tone or Druid .I found none of the above , and I have a small 12x14 room.
1. if you don't play these speakers loud to get the driver moving a 1000 hours is very realistic,ask Sean at Zu .this is why I always tell people let Zu break them in.
at Zu they run them hard and put 150 hours on them, if requested on order, ,LIke myself I played them for 3 weeks straight 24-7 ,and at night with a breakin cd set around 30hz just appliying enough volume to get the driver moving every evening.
then after 300 hours they are just starting to open up.
and everything just gets more focused and refined.
If you have he Druids you should has not more than 1/16
of a inch under the speaker, with a cd case slid underneath for the low frequency vent. if not that will also give you imaging problems .
More to discover