2. speakers
  3. 1140454697

Upgrade from Merlin VSM-M to What?

I have a wonderfull pair of Merlin VSM-M speakers, but I want fuller range. I have the balanced/single ended battery bam and it does extend the bass, but not as low as some other full range speakers. I have been lead to believe that my Karan KA-i180 integrated amp could sound even better with fuller range speakers. I don't want to spend a bundle of money. I just purchased a Pioneer 5060HD plasma and my budget for speakers are $1000.00 more then I will get for my VSM-M's. So my hope is for used speakers costing between $4,000.00 - $4,500.00. My thoughts are toward Dunlavy or Eggleston. Shipping these speakers must be taken into account. I do have sub woofers, but don't use them. They are Velodyne servo 1200's. My integrated does not have preamp outs and I think using the subs x-overs in the speaker line would harm the sound.
stereo
stereo OP
147 posts
 
Thanks Bobby.
I use a single run of speaker wires and cheep, left over old speaker cables, cut into jumpers. I am on the east coast as well about 2 hours outside New York City. I have to run to Philly tomorrow and will try to give you a call before I leave.

Service from Bobby alone makes it a no brainer to keep the Merlins. What was I thinking?
tms0425
72 posts
 
I also have Gregg Straley's Reality speaker cables that I've used with my TSM-MX's. They are excellent sounding cables, however, I'd strongly caution mixing and matching with others in the system. In both situations I've heard them there is some synergy in using his speaker cables in conjunction with the interconnects. Much the same result with Cardas Golden Reference. When I mixed the CGR and Reality Cables, the overall sound was less coherent and becomes thinner sounding with less slam. Good luck - Bobby will take care of you if you ask questions and listen.
sburton
29 posts
 
Stereo,
I have VSM-MX. Love them. I just had the BAM upgraded to Super-BAM staus. I was already getting great bass. Now it's very robust. Very satisfying. Very real. I will say this: If you do indeed purchase other speakers keep the Merlins on hand long enough to make a credible comparison. It temporarily ties up funds to do that, but my money says you will put the "new" one's up for sale and keep the Merlins. Ya want more bass out of em? Give Bobby a call...
bobbyapalkovic
729 posts
 
stereo,
i'll just bet that if you get the merlin/cardas jumpers for that speaker, you will have way better sound and a richer tonal balance. i will explain better when you call but if the jumpers you made use bigger than 15 gauge wire, the dc resistance will be too low going to the tweeter and it will play too loudly. this will shift the spectral balance point up. lighter bass will be the result.
give me a call and i'll get this a lot better for you after you answer a few questions.
regards,
bobby at merlin
shadorne's avatar
shadorne
7,491 posts
 
I guess it depends what you mean by "fuller"....if you mean the sound you hear on the street from a souped up car stereo system then I think the Merlin's will disappoint you....but this sound is not accurate music anyway it is mostly all resonant harmonic distortion.

I suspect that the Merlin VSM-M is doing a fasntastic job especially with your amplifier.

Proper base will not be boomy and room shaking all the time...most often it should be tight accurate and lean ...it is rare that the source material is "boomy", "fat" or "full" sounding.

Try adjusting your speaker placement...remember you get bass cancellations from rear walls at anything less than 2.8 meters from a rear wall!

Try either very far or very close to the rear wall...and avoid corners.
More to discover