Help with Apogee Diva Crossover

Go to:

http://audioworld.com/cgi-bin/sw/forumdisplay.cgi?action=topics&forum=Apogee+Acoustics+Users+Group&number=1&DaysPrune=45&LastLogin=

Apogee users group, get an identity, somebody will know the answer to your question.

I guess you already went there. Why don't you e-mail Florian (Tiny Tim). I am sure he could give you all the info you need.

Madhf: I replied to you at the Apogee forum that the values of this inductor should be 0.05mH. But I am not sure we are talking about the same (L5) inductor as I do not have the manual that you are refering to.

Essentially. there will be only two inductors when you are using the DAX, one for the MR, and one for the tweeter.

The inductor for the MR is 0.05mH.

Hi,

Thank you for your replies, cjfrbw and Gallant Diva. For Gallant Diva: The manual can be downloaded from the Apogee Users Website if you go to the active crossover tab. It looks like I need only 1 of these coils per side, and it's for the midrange. Thank you for the spec on that. Very much appreciated. Happy listening!!

Mike

Madhf:

I did take a look at the manual and yes you were refering to the MR coil. Yes, its value should be 0.05mH. I recommend Alpha Core airfoil inductor.

By the way, you should also add a very large cap in series with the coil to protect your ribbon or otherwise the MR ribbon will flutter a lot, possibly causing a damage in the long run. The value of the cap should be large enough so that it is out of the crossover point, say 200uF.

The bass connection is direct from the input binding post to the output binding post of the passive box. You can bypass that if you like, just to avoid extra connections and cables; that would means the pigtails can be directly connected to the amp driving the bass.