2. speakers
  3. 1160141992

How Does the Vandersteen 2W Work?

Hello,
I can get a 2w sub for cheap and am thinking of getting it to augment the low end of my proac response 1.5's for two channel use. The 2w takes a line level signal, correct? So I would run some cables from the tape out of my preamp into the 2w and make my adjustments (crossover, etc.) at the sub. Would something like Outlaws ICBM bass management thingy be useful? Thanks.
shersta
codrus
2 posts
 
To use the 2W, you need to install the Vandersteen crossover between the pre-amp and the amp, and then run cables from the main amp outputs to the sub. The crossover drops the strength of the bass frequencies, then the built-in amp in the sub boosts them back up again. Running it without the crossover can apparantly damage the sub.

--Ian
Post removed 
swampwalker's avatar
swampwalker
5,138 posts
 
A single 2w will work just fine in my experience, but you will need to run it as Ian has described. Once you have the x-over dialed in using the adjustable x-over, the fixed value x-overs are highly recommended.
More to discover