Is dedicated PreAmp with Oppo 105 needed?

Hi Tim,

I do not have any preamp and exclusively use the Oppo 105 as a preamp.

Currently, the tape deck has been disconnected but I've lots of rare tapes that I would like to listen.

I was also thinking of the same but was not sure if PreAmp had any impact on the sound quality.

Thank you!

I'm not sure what additional info I can provide. I need it for HT 5.1 setup with atleast 2 XLR i/p & preferably 5 XLR o/p.

I got that. What else do you want it to do?

Hitsofmisses hi.

Your Oppo has a digital domain volume control, are you using it's 5 channels direct into your Parasound Halo A51, and the sub output into your sub?
As this is the way I would use it, so long as the digital volume control is at or above 75% of full output, if lower you may run the risk of bit stripping, which is not harmful just robs a little definition the further down you go from 75% of full.

From What/hifi measurements
"Please ensure you enter the setup menu and set volume to “Variable”, then lower the volume control to an initial setting of 45-50 before powering on your amplifier or active speakers after factory reset. Volume setting is retained in memory when the player is put in standby. So volume at power on remains the same as volume at power off.

Output impedance 7.1 board L/R front channels 100Ω

Output impedance dedicated stereo board L/R channels 100Ω

Output impedance 7.1 board all channels except L/R front 200Ω

Recommended amplifier input impedance is 47KΩ (Industry standard)

Peak output level: 2.1 Vrms (RCA / Phono)"

All these output impedances and 2.1output volts are a perfect impedance match for the inputs of your Parasound Halo A51 and whatever sub you use.

Cheers George

Hits,

Since you currently use your Oppo 105 as a preamp and it has no RCA audio inputs, you would require a stand alone separate preamp to be able to hook-up other components such as your Nakamichi cassette deck.

The preamp would be installed between the Oppo and your amp/amps. You have your choice of either RCA single-ended or XLR L+R outputs on the Oppo that you'd need to connect to the preamp's L+R inputs. The L+R outputs on the preamp would then be connected to your amp/amps.

If you do buy a preamp, remember to make sure it has the proper (RCA or XLR)input and output connections to match the Oppo and your amp/amps.

FYI,
Tim

kr4

I’m not sure what additional info I can provide. I need it for HT 5.1 setup with atleast 2 XLR i/p & preferably 5 XLR o/p.

I got that. What else do you want it to do?

Sorry, I think this is what you’re asking. :)

I use primarily for HT (75%) & 25% for Music that are heavy on vocals. I’m leaning more towards Tube based Pre-Amps since I like the warm soundstage. From all I’ve read so far, Oppo’s video processing is very good so I can bypass video on Pre-Amp & connect directly to my 1080P Plasma TV. 
d@kr4: Did I answer your question correctly.

Since the Parasound has 5 XLR inputs, do I need a preamp with all XLR output or an RCA would do?
And does it make a big difference if I connect Oppo via XLR/RCA combo than the HDMI for audio?