Subwoofer: room 16 x 18.5....

Bob, Thank you for your comments. How would you rate the quality of the built in high pass filter? Do you think it would be transparent in a high resolution system?

Magfan,

How would you connect two subs into a system when there's only one sub out connection on a receiver? I am looking into this two-sub solution for an HT setup in a room that will be 16 (W) x 23.3 (L) x 10 (H). Do you just use one of those two female RCA to one male RCA connectors and connect to the sub output?

FrankC

one of those 1 into 2 splitters would appear to be the way to go. ONLY proviso would be if the impedance drops too low. This would only happen if both subs are fairly low to begin with.

If subs are located near the amp, you could also go with speaker level. Are speakers full range? Speaker level input on a sub is very hi impedance so it won't load down amp.

I've seen some plate amps w/both low level inputs and outputs.

Speakers go to 55hz...should I hi-pass? If so..what is the best route to go?