Subwoofer Set up Question

Jax2,

I do not want to run the second line out to my amps as this takes away from running the system via balanced from my preamp and amps. I am thinking of what Marty just described.
The E III's do a decent job on most music but they are in a very large room (24 x 24) with a cathedral ceiling. A sub would help them pressurize the room a bit. Ideally a more capable sub would be the way to go but I had this in a closet collecting dust.

I do not want to run the second line out to my amps as this takes away from running the system via balanced from my preamp and amps. I am thinking of what Marty just described.

You lost me there. You said you had two line-outs at your pre. I'm using the two outputs on my preamp, one going to the sub, the other going to my amp which goes to my Coincidents. I prefer this to running the signal through the X-over components in the sub. So both components are getting a full range signal to deal with. The sub deals with it via the high-pass, phase and volume. I'm not sure what what approach you're considering, but it sounds like the one Marty describes is the same as what I'm using. It is also recommended by ACI. My room is 12X24 with cathedral ceilings (sloped 7 to 11 feet) and getting wider (16 feet), and taller (14 feet) at one end. So perhaps about 1/2+ the volume of your room.

Jax2,

Sorry for the confusion, I am planning on trying to run the set up the same method you are using.

No sweat, CK. It's a good method of going and bypasses running the signal to the main speakers through the crossover circuit. I think it's the best way to go for that reason, but does require some careful setup. An SPL meter or better yet, a computer with a mike and software to plot a response graph can be very helpful.

Jax2,

What frequency do you have the sub set for?