2. speakers
  3. 1259043325

How to isolate bookshelf speakers on a bookshelf

Yes, I know that bookshelf speakers should never be placed in a bookshelf. My situation is a bit limiting. I temporarily need to place my Triangle Titus 202 speakers on the top of a 30-inch high wood credenza/bookshelf, which runs the entire length of the wall.

So they are surrounded by air on the top and sides, and are about 8 inches from the wall.

What is the best way to improve the sound? Should I isolate the speakers from the base using bits of Blu-Tack, or use isolation cones?

Since this set-up will only last a year or so, I don't want to invest too much $$$, but do need to improve the sound.

Also, what are the acoustic reasons why placing the speakers on the top of a shelf degrades the sound versus using quality speaker stands? Is it that there is room for the sound waves to move more freely, or that the speaker cabinet needs to be isolate from resonant objects? Or both?

Thanks.
kixo
drdennis
165 posts
 
On top of a cabinet is much better then in a bookcase.
Blue-Tack will couple the speaker to the cabinet. Footers will have a different effect. Try both.
You can experiment with Vibrapods and Vibrapoints for relatively little money, and later use them under other components.
tpreaves's avatar
tpreaves
2,686 posts
 
I know it's a pain in the ass when you have limited placement options.I have dealt with that before.With the 202's being front ported you can use them relatively close to the wall.I would not put them in a "cubby hole" though.Be aware, if you use vibrapods,they will stain whatever the rubber is touching.Try some of the felt pads that are used to protect wood floors.Good luck.
stanwal's avatar
stanwal
3,147 posts
 
Go to a place that sells foam rubber mattresses and get some pieces of scrap foam. They should be cheap/free. Put them under the speakers and see if it helps. If it does you can use them or pursue a higher tech solution along same lines. Have you considered suspending them from the ceiling using some of the nets used for plants? I once heard LS3/5As set up in this manner and it worked quite well.
swanny76109
382 posts
 
I had a setup at my old house with Von Schweickert VR1s in my built in bookshelves. I used a quasi blu-tack product I got at my hardware store (it is blue and can't remember the name but you find it where they have the picture frame hooks)and it worked great. It comes in flat strips. I just cut 4 squares for each speaker and stuck them on the speaker, then positioned the speaker where I wanted. It tightened and warmed the bass at the same time. No issues of marking speaker or shelf, or paint peelup.
More to discover