NHT help

I dont know if biamping will do much for you. You will have to be the judge. With the low pass set at 35hz you are essentially running the speakers full range.

I do think that you need to be careful about level matching. There is a lot going on now.

I agree with Robr45 - with the low pass set at 35 hz you aren't accomplishing much. I would try 80 or 100 hz.

Did you try emailing NHT's customer service? They have been very helpful for me.

Mark

I was doin a bunch of reading last night and I need to go in and change some of my settings.The only time I use the sw-3 is for movies,when I listen to music I use a direct stereo mode that just plays the fronts.I did contact nht and they did respond,just trying to get everyone idea's here.

should I use 1 sa-3 or 2 sa-2's?

here is the options i have or should I say the amps i have to work with:2 sa-2 amps,I also I have a extra sa-3 amp in the box that I would have to have repaired and a sw2pi.
1.use the 2 SA-2's bi-amp the 2.5 and be done with it(if its worth it)
2.Use a single sa-3 and by amp the 2.5;s and be done with it.
3.leave the speakers alone and sell the 2 sa-2,the sa-3 and the sw2pi and be done with it.
Really need some advice here