2. speakers
  3. 1268526054

Speaker jumpers on Tannoy System 12's

Good day, folks...can anyone advise me here? I'm running single speaker wires into bi-wirable speakers (Tannoy System 12's). Should I attach the cables directly to the HF posts and jumper 'down' or vice versa? Does it matter? And are these 'built in' jumpers on the Tannoys removable or replaceable? Thanks very much.
mthowe
Post removed 
mthowe OP
8 posts
 
Thanks! Very helpful.
tpreaves's avatar
tpreaves
2,686 posts
 
Try both ways and see if you can tell a difference,chances are you won't.
4est
507 posts
 
They are basically binding posts and they can be replaced, but you would need jumpers if you weren't bi wiring and/or need to adjust the tweeter. Remove the screws on the back plate (careful, the coil may be attached to the box separately). Remove the screws to the circuit board and below it are their binding posts. If you do replace them, shoot me a email. If you are reasonable I'll buy them from you.
More to discover