SMS-1 Questions

Kal,

So it sounds like you are saying the SMS-1 with a mono signal to both might be the way to go rather than getting the Auddysey and having to add some sort of cross-over to compensate for the latend delay?

If I were to use the SMS-1 and wanted to let my mains run full, what would be the best way to hook-up the SMS-1?

Use a pair of Y cables from the preamp to split off the L/R signals for the SMS-1. (I cannot remember if one can use the SMS-1 to do this but that might be possible.) There is a small delay introduced by the SMS-1 but that is folded in with the rest of the adjustment you will do to integrate the subs with the main speakers. However, you should also use the SMS-1 display to assist you in placing the subs as optimally as possible before invoking the EQ.

Frankly, I would prefer real bass management with delay/level/crossover including a HP filter for the main speakers but that does not seem to be where you are going.

Kal,

If you were going to go the way you suggest (full bass management) how would you proceed with true full range speakers?

Full range is, already, contentious since there are different definitions for it. In addition, without measurements, there's no assurance that they will perform as "full range" in any particular setup.

With the B&W 802Ds in my city system, I use them as full-range, no sub, for casual stereo listening. Sometimes, I invoke bass management (40 or 80Hz) but I always do it for multichannel.

With Paradigm Studio/60s in the country system, I always bass manage at around 40-50Hz (varies per speaker).

All that said, I am unfamiliar with almost all the equipment you have in your main system.

Kal