Any comments on DAC directly to Power amp with no

Thanks George,
I'm interested in Hgeifman's listening impressions as I suspect that both methods can sound quite good but certainly different.
I happen to agree with you in regards to balanced compared to single end RCA. The simpler RCA usually sounds better to me despite the touted advantages of going balanced. Certainly fair to say YMMV. On the other hand I do hear advantages with balanced AC power compared to non balanced AC.
Charles,

Well, I am using a BSG QOL after my PS Audio Direct Stream Dac. So, technically not quite direct to the Amp.
However the PS Audio Dac controls the volume etc.

I have had beautiful results either way, with or without a preamp. However, lately the DACs are becoming SO good that putting a preamp in the chain is putting something in the road that doesn't need to be there.

I am a strong advocate of shorter signal path typically being superior. This has almost always been the case, especially in terms of cleanness, detail and microdynamics. The issue is whether one can get the desired macrodynamics, soundstage and tonality. If those can be obtained via a DAC to amp setup, the results are breathtaking!

The problem is, most DACs can't do it well enough. :(

08-18-15: Hgeifman
I am concerned about having a fully balanced DAC running into a fully balanced amplifier and NOT take advantage of the two balanced units. My test should help me decide how to proceed.

Although the L-590AX is described in various places as being fully balanced, I'm not sure that is the case. First, it seems unusual for a balanced amp to provide most of its line-level connections via RCA's, as can be seen in this rear panel photo, including the pre-out and main in connections as you mentioned. Also, the lightning bolt symbols near the speaker terminals, which are presumably intended to alert the user to the possible presence of high voltage, are adjacent to each of the red terminals but none of the black terminals. (A balanced amp would provide voltages on the black terminals that are essentially identical to those on the red terminals, aside from a polarity inversion). Also, in many cases a balanced amp will have a statement on the rear panel cautioning against grounding the negative (black) terminals, which is not present in this case. Check and see if the manual has such a statement; if not, it would cast further doubt on the amp being balanced.

So in the event my suspicion is correct, as George suggested above supplying the amp with a single-ended signal may actually be preferable to supplying it with a balanced signal, since it would eliminate a balanced to unbalanced conversion from the signal path.

Also, if you have a multimeter available you could make some simple measurements to verify whether or not the amp is fully balanced. Post back if you'd like further info on how to do that.

In any event, good luck as you proceed.

Regards,
-- Al

Fully balanced components usually list 2 sets of specs.