2. tech-talk
  3. 119110-1453

What's that noise?

I am running a Plinius Tautoro into a Plinius SA103 amp. When I turn the volume to maximum with no input, I can hear low level white noise from the tweeter and a similar but more "jagged" sounding white noise from the mid range driver. I am running the system on a standard household circuit (including outlet) through a Furman Elite 15PFi. What might be the source of this noise? It does not sound like 60 cycle hum.
falconquest
swampwalker's avatar
swampwalker
5,138 posts
 
Hard to  be certain w/o knowing what kind of speakers you have or what their efficiency is and how far away you are standing, but at full volume you hear a little white noise, that does not sound unusual to me.
tom6897's avatar
tom6897
1,484 posts
 
Me either.
georgehifi's avatar
georgehifi
10,312 posts
 

If this only happens at full max volume rotation, could be the pots wipers are going open circuit, and the input of the next stage (output line amp section) is seeing this open circuit and will be noisy. If this is the case and it’s fine when you back it off from full a little, then don’t worry about it.


Cheers George

falconquest's avatar
falconquest OP
1,108 posts
 
Thanks for the replies. The speakers are Legacy Audio Focus rated at 4 ohm and 96db. The "noise" does stop just below full volume and there is no way one could listen at this level. I usually don't use more than about 33% of the potential volume level.
More to discover