Donzi, "usually" the better speakers "less coloured" are the harder ones to drive, brands like Wilson and many others even worse than Thiel.
Cheers George
Recommended amp for Thiel 3.6 -- newbie
Hello all. As a newbie to this, I’ve read a number of the forum posts, and have gotten some wonderful information and education. And, as this particulary question, Thiel 3.6 recommended amps, was pretty old, thought I’d post my own specific questions. I know so little about this, I’m sure to make some idiotic mistakes, but I’ll learn.
I just purchased a set of the Thiel 3.6s, and then read that they’re significantly hungry for both power and quality components. Although my budget is not unlimited, I have no buyer’s regret, as these seem to be a wonderful speaker set to grow into, with advancing upgrades as time goes on.
My room is about 27’x40’x9’, rug floor, combined living room, dining room; with the entertainment center in the right half of that space. My listening area is about 14’ back, and I generally expect to listen at mostly low to moderate levels. I like accurate, but I don’t like loud. I confess the system I was looking at was Denon AVR-x7200, rated at 150wpc -- but even that is confusing to me: One place says 150wpc, another 260w. The specs seem to be high at 0.05% THD, but the boards seem to reflect that many aren’t a fan of the Japanese disclosures. On all the boards I’ve read, no one recommended that system, in favor of, say, Theta, McCormack, Adcom and others. And the crickets were pretty deafening.
My prime use is for music from those speakers; but I would love to plug in HT application as well, with ultimate 4k passthrough, Network Attached Storage, Internet Radio, and Airplay and/or AppleTV -- those are the things that led me to the Denon in the first place. And even though the boards were critically silent (only one reference, and a negative one at that), I wondered if it was simply because those threads were old.
So for now, I’m kind of looking at Theta -- almost certainly in the used market. I saw a Dreadnaught unit go off recently, so perhaps with enough patience a similar thing might come around again. And see also (currently) a Casablanca unit. --But this is confusing. The Casablanca seems to return some of the HT features that I’d like, and while I’d like to think this is a solution, read the term "pre-amp", which suggests to me that this alone would never be a solution to power those Thiels. Perhaps this AND Dreadnaught. Or something similar. Or something else. --And for that matter, might the Denon 7200 itself, if not an ideal system, be used as a "starter system" -- acceptable for now -- and then morphed in pre-amp type of deal later, using it's connective controls, with some sort of quality amp downstream?
Thanks much for the consideration to this question and long post.
I just purchased a set of the Thiel 3.6s, and then read that they’re significantly hungry for both power and quality components. Although my budget is not unlimited, I have no buyer’s regret, as these seem to be a wonderful speaker set to grow into, with advancing upgrades as time goes on.
My room is about 27’x40’x9’, rug floor, combined living room, dining room; with the entertainment center in the right half of that space. My listening area is about 14’ back, and I generally expect to listen at mostly low to moderate levels. I like accurate, but I don’t like loud. I confess the system I was looking at was Denon AVR-x7200, rated at 150wpc -- but even that is confusing to me: One place says 150wpc, another 260w. The specs seem to be high at 0.05% THD, but the boards seem to reflect that many aren’t a fan of the Japanese disclosures. On all the boards I’ve read, no one recommended that system, in favor of, say, Theta, McCormack, Adcom and others. And the crickets were pretty deafening.
My prime use is for music from those speakers; but I would love to plug in HT application as well, with ultimate 4k passthrough, Network Attached Storage, Internet Radio, and Airplay and/or AppleTV -- those are the things that led me to the Denon in the first place. And even though the boards were critically silent (only one reference, and a negative one at that), I wondered if it was simply because those threads were old.
So for now, I’m kind of looking at Theta -- almost certainly in the used market. I saw a Dreadnaught unit go off recently, so perhaps with enough patience a similar thing might come around again. And see also (currently) a Casablanca unit. --But this is confusing. The Casablanca seems to return some of the HT features that I’d like, and while I’d like to think this is a solution, read the term "pre-amp", which suggests to me that this alone would never be a solution to power those Thiels. Perhaps this AND Dreadnaught. Or something similar. Or something else. --And for that matter, might the Denon 7200 itself, if not an ideal system, be used as a "starter system" -- acceptable for now -- and then morphed in pre-amp type of deal later, using it's connective controls, with some sort of quality amp downstream?
Thanks much for the consideration to this question and long post.
- ...
- 33 posts total
Look at the Sanders Sound Systems Magtech amplifier . He makes very high current amps. The suggestion for a Krell was good but probably better if you get an older Krell that has been restored. Use a newer processer as a pre amp that can accept all of those sources. Simple answer and watts are not the issue as you have found out. Look for a high current amp like the Magtech with a fast slew rate and stability down to 1 ohm. |
Donzi, I'm a bit late on this post so I'll try not to just repeat all of the good comments of others regarding the need for a high current power amp. But I would add that high power is not necessarily all that important unless you are actually going to listen to this at high levels (you indicated that you don't do this). The difference between 50 amps and 200 amps is only 6db, not all that much. I bought my Thiels when they first came out and consumer information then was minimal. I went through a lot of high power amps but had no success until I bought a 50W Class A amp made by Threshold, the SA3. Not only did it drive the Thiels adequately but is was very smooth and truly neutral tonally, not really emphasizing any part of the spectrum, well maybe a bit warm especially by todays standards. What made this important was that many of the amps I tried were not really smooth thru the upper mids and highs and the resulting sound was etched/harsh/bright. So if at all possible you should listen to any amp you might buy in your home with these speakers or you risk wasting your time and money. On the subject of 'recommendations', I'd place more value on those from folks who have actually had these speakers in their own homes and went thru the set up drill. Generic recomendations don't mean much with Thiels. The Thiels you have, and most of the other Thiels as well, are fine speakers, but they all demand not only high quality matching amps but upstream components as well. Garbage in - garbage out. Really! BTW, you could use your Denon as you suggest and replace it with a quality pre-amp when you get some funds. I replaced my pre-amp with a then SOTA tubed pre-amp (huge difference!). If such a possibility is on your horizon be sure that any amp you purchase has the high input impedance to match the often high(er) output impedance of tubed pre-amps. Good luck with this adventure. |
Thanks all. So I’m focusing on a good, current or vintage two channel amp. (Used, lower price and I’ll take my chance on repair need.) There are several choices including the great ones you’ve all suggested here. Current focus for this purpose is perhaps Mark Levinson 23, or Bryston 4bst -- or one of the others. Now for the pre-amp question -- quality in! (I now get that.) But before I move off into the two-channel pre-world, like perhaps Casablanca, is there a solution such as this Marantz pre that would not overly color the signal in? (Or perhaps if it leaves the signal unmolested, this lesser version.) Or am I understanding the hard truth that this is going to crap up the system even though it’s not having an amping function? And even so, tis, you spoke of the full quality two channel (end-to-end) system, with alternative, cheaper HT passthrough. Would that linked system above accomplish that? Or when you talk about pass through, is there a system that allows this to do so far more unmolested? In all cases, is there any chance that a system such as that can be combined such that (with those features) it can be the "turn-on-and-control-all" system including the quality two-channel system? Or in all cases, am I going to be looking at a tradeoff choice of those features vs. quality? If so, I’m a little puzzled, tis, by what you’re suggesting in terms of integration, as it seemed to imply that there was a solution that would fit what I was looking for. In other words, I'm suspecting that if I ultimately want any HT, I might have to hit multiple on switches for multiple systems to get both quality AND HT. (Although I’m sure I have that pretty muddied up at this point.) I did go listen to the Denon today, and INSTANTLY dropped it from consideration. Heard a lesser powered Marantz amp (which arguably is the same quality realm) but had nicer sound -- which then led me to the question of the possibility of using Marantz simply as a pre system, hoping to bring me even closer to a full picture, including quality. But again, outside of an expensive pre system, I understand I may not have an option. In all cases, budget will probably have me piece a system together in steps, starting with two channel music, adding streaming audio and the like, and perhaps TV somehow, down the road. |
- 33 posts total