Selling Damaged Magicos

The magnets may have come unglued and locked the woofers up also.... Can you move the cones?

I put another battery in. The reading of 1 I thought I was getting is actually in the hundred place like 1 _ _._. I am getting various readings from 1.0 - 190.0+ when I touch the leads. When I touch the speaker terminals, it stays at 1_ _._. It kind of seems like there is not a connection and nothing is going through. I attempted taking out a woofer. The screws on the woofers take small allen wrenches. I put almost enough pressure on it to break the allen wrench and it didn't turn. This is when I get concerned about my DIY skills which have never been good. I sure don't want to damage anything worse than what it is. Someone could probably take these speakers and put a little effort and money in them and have a nice set of speakers at a low cost.

The guy you sold them to could've had the same speakers and switched his defective parts into your speakers, happens all the time, where are you located? Maybe one of the members here that lives near you and knows how to work on speakers and diagnose the problem can help you out, It's simple to do and only takes a few minutes to figure out what's wrong with them.

I am getting various readings from 1.0 - 190.0+ when I touch the leads.

Then it sounds like something is wrong with the meter.  It should read very close to zero ohms when the leads are touched together, and the reading should be steady aside perhaps for a fluctuation of 1 count in the least significant digit.

All I can suggest at this point is to try the suggestions made by Peter (pbnaudio) and Paul79.

Good luck.  Regards,
-- Al

Thanks everyone. I'm in eastern KY.