Will Changing my 100 Watt Tube Amp to a 200 Watt SS Amp Solve My Problem?


Hello All,  I have a 100 watt Audio Research VT100 mk II amp, with an Audio Research LS-25 preamp.  My speakers are relatively low in sensitivity, and I find that I must turn the volume up to 3 o'clock on the preamp to get enough volume for a loud listening experience.  When I do that, I am introducing more background noise.

I would like to achieve a quieter noise floor.  I am also curious about the limits of the 100 wpc amp with the Mira Monitors.  Would an older Krell 200 watt class A amp "control" the speakers better?  If so, what are the benefits of this?  There are a few amps on this site that caught my eye, all about the same value as my amp, so I can potentially make a move with very little cost.  Is this a good idea? How much wattage increase is necessary to get a significant enough difference?  Would a jump to 150 watt solid state be sufficient?


here are the 3 amps that caught my eye:

Ayre: https://www.audiogon.com/listings/solid-state-ayre-acoustics-v-5xe-amplifier-2016-02-05-amplifiers-h...

Krell: https://www.audiogon.com/listings/solid-state-krell-ksa-250-2016-02-14-amplifiers-91754-monterey-par...

BAT:
https://www.audiogon.com/listings/solid-state-balanced-audio-technology-bat-vk-250se-bat-pak-2channe...



You can see my complete system here if you want to know more about the other components:  https://systems.audiogon.com/systems/5421



Thanks!
Mark
marktomaras
I don't think your issue is power but sensitivity. Sensitivity in a power amp means how much power out do you get for a number of volts in from the preamp. You need either a preamp with more voltage output or a power amp with higher input sensitivity. Doubling the power will not solve your gain problem
Alan
if you don't have enough phono gain no larger amp will help.
either higher output cartridge or higher gain phonostage will cure your problem.
This is not a power amplifier issue!

This is a noise problem in the preamp. Ahendler got it right.
Ahendler got it right.
Not sure about that, Ralph.  His statement that:
You need either a preamp with more voltage output or a power amp with higher input sensitivity.
... does not appear to be consistent with what I said in my post above, and I therefore disagree.

Best regards,
-- Al

Al, when you turn up the volume and that results in noise, that is a preamplifier problem. Its true that the amp might have a certain low sensitivity requiring a higher volume setting, but even if the amp was more sensitive, you would still get the same noise even though you didn't turn up the volume as far on the preamp.