2. analog
  3. 1439398250

6SN7 tube question

Hello,

I need to replace the tubes in my Rogue 99 line preamp, which uses the 6SN7 tube. I was looking at an online seller who offers the following options with an affordably priced 6SN7 for a few dollars extra:

1. Balanced Triodes
2. High Gain
3. Low Noise and Microphonics
4. Matching

Options 3 and 4 seem most desirable for a preamp. My question is whether it is worth the extra few dollars (approx. $6 per tube) or is it just a pure marketing ploy to get suckers like me to drop more dough?
actusreus
wntrmute2's avatar
wntrmute2
188 posts
 
I would also check out Brent Jesse as a tube source.  He is honest and prices his stuff reasonably.  Has a whole section on the 6SN7 and variants.  He usually carries a Baldwin labeled tube which looks and sounds identical to the much more expensive Sylvania chrome top.  I have had good results dealing with him over a number of years.
johnnyb53
3,510 posts
 
+1 for Brent Jessee. I've bought a fair amount of stuff from him over the years. I've also had some good luck with tctubes.com. Four years ago I got an out-of-production NOS Philips JAN 6X5WGT rectifier for $21 + $5.50 s&h from tctubes.
john_tracy
343 posts
 
I'm a bit frustrated as I've had to replace the tubes just about once a year even though I listen on the weekends only,

Check the filament voltage. If it's much more than 6.3vac then you will need modify your unit to lower the voltage. I have a Sun SV2A3 that was eating 6SN7s and the filament voltage was ~7vac.

actusreus OP
733 posts
 
John Tracy,

How do you check the filament voltage?
almarg's avatar
almarg
9,670 posts
 
How do you check the filament voltage?
It would have to be checked by touching or connecting the probes of a voltmeter (or a multimeter set to measure volts) to the filament pins of one or more of the tube sockets, under the chassis, or to some other circuit points that are connected to those pins. (To assure a meaningful result the measurement should be done while the tubes are in their sockets, as opposed to removing the tubes and accessing the socket pins from above the chassis). Lethal voltages will be present on some of the other pins on those sockets, as well as elsewhere under the chassis. And if the probe tips were to momentarily come into contact with two adjacent pins simultaneously damage to the component may occur. So it’s a task that is best left to a qualified technician.

Also, regarding the references to 6.3vac and 7vac, many designs provide dc voltages to the tube filaments rather than ac. In those cases, of course, the meter function should be set for dc volts rather than ac volts, and the probes should be connected with appropriate +/- polarity.

Best regards,
-- Al

More to discover