2. cables
  3. 123763-72742

Cable length dilemma!

Ok, so here's the dilemma: speakers placed on either side of a fireplace, impossible to place the amp between them. Only place to put the amp is just to the left of the left speaker, leaving a 1-foot run to the left speaker, and a 9-foot rum to the right speaker. I have always read that your L/R cables should be the same length, but in my case that would necessitate coiling 8ft of the L cable underneath the rack, which is the lesser of two evils here - mismatched length, or a big coil of cable under the rack?

128x128ilikemiles
grinnell
1,094 posts
 
same setup here- 2 runs of 13 foot Kimber PR8  one run is bunched not coiled up :)
don_c55
1,025 posts
 
The increased inductance effect of coiled speaker cable in not audible!

Too small to be of significance.

Do not run speaker cable along side power cords.

Do not run speaker cable along interconnects (only cross at a right angle if necessary).
xti16
1,525 posts
 
The worst part is if you ever want to sell the cables.
kijanki's avatar
kijanki
4,428 posts
 
Inductance of straight wire is about 0.2-0.4uH/ft for gages 10-20. In the speaker cable this inductance is greatly reduced because of return wire (currents in opposite directions) especially when wires are twisted (twisted pair or helical twist). Coiling such cable should not increase inductance since magnetics flux created by wires conducting identical currents in opposite directions should be zero, pretty much like in the common mode choke that has close to zero inductance for normal mode currents.

If you believe that speaker wire has any effect on the sound - it will be proportional to length of the wire.

xti16 +1
More to discover