2. amps-preamps
  3. 1448317474

Synergistic Red Fuse ...

I installed a SR RED Quantum fuse in my ARC REF-3 preamp a few days ago, replacing an older high end fuse. Uhh ... for a hundred bucks, this little baby is well worth the cost. There was an immediate improvement upon installation, but now that its broken in (yes, no kidding), its quite remarkable. A tightening of the focus, a more solid image, and most important of all for my tastes, a deeper appreciation for the organic sound of the instruments. Damn! ... cellos sound great! Much improved attack on pianos. More humanistic on vocals. Bowed bass goes down forever. Next move? .... I'm doing the entire system with these fuses. One at a time though just to gauge the improvement in each piece of equipment. The REF-75se comes next. I'll report the results as the progression takes place. Stay tuned ...

Any comments from anyone else who has tried these fuses?
128x128oregonpapa
oregonpapa's avatar
oregonpapa OP
4,867 posts
 
tbg ...

 Too old for vinyl? When does that happen?  :-)

Newport is almost here.  Looking forward to meeting some of you folks. 

OP
goldencutt's avatar
goldencutt
8 posts
 
OP & C1D & David

i do appreciate you all share your experience here.
I would like to give you a update due to my last change to the black fuse. Today we changed the fuses in the active bass-amps. Expensive experience, since there are 5 in each amp. :-)
After that change the picture became what oregonpapa experienced, huge, colorfull and so on. The audience when you listend to Music registered live, is huge. Handclaps are real which is a hard thing to do.But the the presentation of the space is woooow.
Never heard before.The Direction of the Fuse is against the Writing. It sounds like out of Phase otherwise and not focused. Did someone already tried out SR power cords made which are using the same technology then the fuses? 

Enjoy your Music. 

GC
davidpritchard's avatar
davidpritchard
866 posts
 

goldencutt:

Congratulations on your sonic improvement. Your system sounds like it has achieved the level so many desire and yet so few obtain.

Ordering ten fuses and then taking the time to orientate the fuses takes courage and dedication that many lack.

I hope you will try the Synergistic Research Black outlets in your system. They do use the same technology as the fuses. And like the fuses, they need 100 to 200 hours to fully settle in.

David Pritchard

charles1dad's avatar
charles1dad
10,250 posts
 
Hi goldencutt,
Congratulations on your very gratifying outcome with the Black fuses. 
Charles, 
jafreeman's avatar
jafreeman
693 posts
 
Just installed SR Blacks in my Maggie 3.6Rs.  The blacks have replaced the reds, which sounded remarkably better than the Furutechs and SR20s. Two hours in--the blacks sound just as good as the reds right out of the box--I am hearing midrange information that was not audible with the reds--more space and decay, more inner detail. I am not hearing any of the harshness or lack of focus forewarned of before full burn-in.  Perhaps this is because of their function in the signal path--they are not being held back.  As with my reds, the blacks are 8A and 16A in the tweeter and midrange positions, far exceeding the stock 2.5A and 5A ratings. The larger filaments provide a more robust presentation--this has been the case with all the brands tried--like using a larger gauge wire.  The fuses are no longer protecting--just improving. I look forward to an ever sweeter, wider soundstage as these blacks settle in for a few days. 

Another score for those who have been believers--sorry naysayers and skeptics--these fuses are providing sound improvements that far exceed bias expectations or other variables such as cleaner contacts because  of fuse changes.  Try 'em!  

More to discover