2. home-theater
  3. 1289213443

integra 80.1

hi all i just got an integra 80.1 and i have a question about the set up.

i have m&k speakers that are 4 ohm. my old onkyo that i was using had a speaker ohm setting (8,6,4). im not sure if i misread the manual but i cant seem to figure out how to select the speaker ohms on the integra.

can anyone help?

thanks
nineballg
hifihvn
943 posts
 
Pages 54-55,set to 4 ohm setting under first time setup.Link. [http://filedepot.onkyousa.com/Files/own_manuals/DTR-70.1_80.1_En_web.pdf?CFID=1260084&CFTOKEN=20724004&jsessionid=f0308c64dd069e5119396f792f3e29581373]
nineballg OP
35 posts
 
thanks, the link you gave me is for the dtr receiver.
sorry i forgot to specify that i have an dhc 80.1 processor and it doesnt say in my manual.

infact, the dtr 80.1 link that you sent for the manual is a little different than my manual.

thanks
hifihvn
943 posts
 
A preamp/processor normally doesn't have a impedance (ohm)selector for speakers.It does most likely have a crossover for small,or large,or frequency to cutoff bass to the speakers. Your power amp may.If your power amp does,it would most likely have a switch on the back of it (power amp).The power amp should say how many ohms it handles on the back of it too.
More to discover