2. home-theater
  3. 1323786801

System shutting down due to clipping?

From time to time my HT system shuts off when playing at higher volumes. The Yamaha AV unit is running out of juice and I assume it is tripping off as a self preservation function. I am guessing that the rear surround speakers are the culprits since they are 4 ohm. I am not sure whatload the center channel is.
SO how do I fix this? I do not want to change the AV unit and am not real keen about changing the speakers either. Don't even think of suggesting that I turn the volume down.
128x128blueskiespbd
chadnliz
3,736 posts
 
I doubt its heat but goid luck all the same.
blueskiespbd's avatar
blueskiespbd OP
161 posts
 
I am not sure it is heat either. The unit in on the top open shelf and doesn't seem hot. What do you think?
rrog
1,958 posts
 
I think you need a more powerful amp, more efficient speakers or you should learn the limits of your system.
chadnliz
3,736 posts
 
Ditto Rrog
erikt
269 posts
 
Just to stir the pot a bit more.

The OP may be able to keep his current AVR and IF it has pre-outs, he could add an external amp.

Couple of choices:
1) 2-channel ext amp for Front L/R speakers - which may 'offload' the AVR enough to drive the remain speakers
2) multi-channel ext amp: 3 or even 5 channel and completely offload the AVR from driving any speakers.

Would be helpful to know which Yammie AVR model the OP has.

I still have my Yamaha RX-V1800 as my AVR for a 5.1 setup. At one point I had my old Carver M-1.0t hooked up via the AVR pres for Front L/R ext amplification, and could go "stupid loud" for all channels.
More to discover