Do equipment stands have an impact on electronics?


Mechanical grounding or isolation from vibration has been a hot topic as of late.  Many know from experience that footers, stands and other vibration technologies impact things that vibrate a lot like speakers, subs or even listening rooms (my recent experience with an "Energy room").  The question is does it have merit when it comes to electronics and if so why?  Are there plausible explanations for their effect on electronics or suggested measurement paradigms to document such an effect?
agear
There are a bunch of really interesting designs for audiophile and non-audiophile iso stands, many of which are actually not active designs, not the least of which is the complicated Minus K negative stiffness stand and the magentic levitation types. I appreciate any device with very low resonant frequency, for example 0.5 Hz is a very good number. The Vibraplane and Minus K both came to audiophiles courtesy of Newport Corp, the mother of vibration isolation devices for industry, active and passive.

I also like the idea of dual mass-spring layers and even sapphire threads or even fishing line for want of sapphire thread. Lol I’m also a fan of DIY bungee cord device in lieu of the usual DIY tennis ball or bicycle inner tube type stuff. I also like to suspend all cables and power cords using springy rubber bands or thread with rubber bands on the ends.

finally, as I’ve intimated before, aside from the technical aspects, there is an art to isolation: how much internal damping, how much damping for the top plate, how to interface the component to the top plate, how to interface the iso device to the floor or rack, all these issues are critical for obtaining the best sound.

cheers
That's great feedback Ralph and describes precisely what I have experienced.  Since you are an engineer and manufacturer like Geoff, any thoughts on why SS devices would be vulnerable?
The semiconductors themselves are microphonic. I've seen some (in need of replacement obviously) that rang like a bell when you ticked them with a small screwdriver, just like a tube.

I've also seen cables and capacitors be microphonic. One time a highly respected high end cable manufacturer made a set of cables for our Neumann U67 microphones, which I was eager to use, but regrettably the cables were so microphonic (tapping on them was easily heard at the mixboard) that they could not be used at all! The stock Neumann cables made much less noise.
The word "microphonic" itself is a little ambiguous as even tubes that are referred to or marketed as non-microphonic are in fact slightly microphonic, which can be easily demonstrated by using some effective tube dampers. Furthermore even things like circuit boards or cables or solid aluminum chassis that are not "microphonic" or considered to be "microphonic" are susceptible to vibration when excited by their resonant frequencies. That’s the case whether the component is tube or solid state. Funny story. A friend of mine said watch this. He was sitting in a chair on the other side of the room from his stand with a CD player on the top. Next to the CD player was a glass of water. Next, he began tapping his knee with his finger very softly. Immediately ripples appeared on the surface of the water in the glass, synchronized with the tapping.