VPI versus Ultrasonic cleaners


There have been rave reviews concerning ultrasonic record cleaners of all types.  But no ones has ever put the records under a microscope.  I am posting this because I have at 130x.

I purchased 2 of the same records, 1 ultrasonic cleaned and 1 not.  I examined them and the ultrasonic cleaned record while cleaner was not fully clean.  I contacted the seller and this was one of the drip dry cleaners.

I gave the ultrasonically record the following light cleaning (which did help it)
1 Docs miracle record misto sprayed and spread with a cotton makeup remover
2 Steam with distilled water
3 Vacuum with my VPI with a Delron tube (much better than the cheap clear one)
4 VPI record cleaner misto sprayed and spread with VPI brush
5 Steam with distilled water
6 Vacuum with my VPI
7 Steam with distilled water

The other record received the above process but repeating steps 1-3 and 6-7.  So twice the cleaning

I re-examined them under 130x and showed the results to a couple others who agreed that while clean the double VPI processes looked better.

Listening wise they sounded the same.  Listening was done on a SME20/3 with a Sumiko Palos presentation cartridge.   Any difference should have been picked up.

Shame I can't quickly post the pictures.  But in short if you have a good VPI process perhaps invest in a USB microscope and look at the record before buying another cleaner.  If you do get an ultrasonic cleaner I think it needs to be the drying kind.

ajcrocker1

I was told by the rep for the Audio Desk cleaner (at RMAF) that vacuuming the record adds static to it. This is why they choose to air dry the record after the wash cycle.

ajcrocjer1: What ultrasonic cleaner did you use? Were the 2 test records equally dirty to begin with?

Use quats in your cleaning solution and detergents with a neutral PH balance to eliminate static. I get no static from vacuum drying. Air drying leaves the residue from whatever was in the tank solution, including the contaminants that were on your records originally (now just diluted).
I have an Audiodesk and sounds like a good idea to use the VPI to give a final rinse. Also have zerostat, Mapleshade zerostat and Furutek d'stat. I will post after I try
Rushton is right again. The minimal amount of static I get from the VPI which dries in 3 rotations can be eliminated with a Furutech Destat or similar tool. This is better than dried solution left on the record after an AD blow dry. That said, I have used the AD without a final rinse to great effect. But, when you are already in the insane clean program: Why have any impurities on the record? Why not go all the way? 
What final rinse do you all use? I see that Audio Intelligent makes Ultra-Pure Water available from music direct for $16. I also see several reagent grade water types on amazon.