incorporate 2 channel amp into multichannel system


Is there a way to incorporate my creek destiny amp into a multichannel system? I want to use it to power my fronts and buy a multichannel receiver to handle the other channels. This way I can keep my 2 channel system intact for music. This already sounds impossible but if there's a way please let me know.
vincent25
Does the Creek have an HT Bypass function? If so, that is what will do this for you.

Kal
I'm not familiar with how an HT Bypass works, but you can do what you want by getting a home theater receiver with preamp outputs. Then hook the preamp outs for the L&R mains on the receiver into a line input on the Creek. Hook your center and surround speakers to the receiver as you normally would. When you set up the receiver's multi-channel balance, set the volume control on the Creek to 12:00 (or some other easy-to-remember setting). When you want to watch a movie, just switch the Creek to whatever line input the receiver is hooked to, turn the volume on the Creek to 12:00, and you're set.
Minkwelder is almost correct with one caveat. You need to trim channels levels on the receiver (using an SPL meter), based on the volume setting on the line input on the Creek. if a 12:00 setting represents say -20 db, you would have to offset by adding 20 db on the SSP which may be out of range. You will probably need to find something closer to unity gain on the Creek. However since you have no step attenuation with a volume level readout display, you need to set it at a high level (say 3:00) and possibly mark the correct volume level setting for HT mode with a piece of tape.
Yep, Edorr is correct. My bad for attempting a quickie response. The 12:00 setting has worked for me with my Yamaha receiver and the three different active preamps I have used in my 2-channel setup. The Creek is a much different animal. Not only does its preamp have a passive stage, but it also has three selectable gain stages. The actual volume control setting on the Creek will depend on several variables, including the output level from the receiver's preamp. A higher volume control setting on the Creek may be necessary to remain within the receiver's range.