Is DEQX a game changer?

drewan,

Though the Premate unit was purchased as used, I was told that it was never used just the box was opened up. Perhaps it was used as a demo. Everything about it looks brand new.

Thanks for your comments on the BSG QOL. Tomorrow, I will try the high analog output from the DEQX into the QOL with the QOL then going to my amp. My logic is that I have the speakers and room set up with the DEQX, so I should be able to hear what the QOL adds. But, I also intend to try it the other way too, that is before the DEQX.

I changed the fuse to the SR Black, but I am confused. The unit says to use a 2A fuse but what was in it was a 1Amp.

I also changed the jumpers settings, while inside I noticed that the mother board says HDP-4 which is perhaps a good thing. But, on the power cables going to the IEC there is a cheapo snap on RCA ferret, perhaps a bad thing.

ozzy

drewan77,

Thanks, If the QOL is placed before the DEQX Premate would I need to run the measurements again?

drewan77,

Thank you. I did place the QOL before the DEQX and I did do a complete calibration including speakers, subs and the room.

At the end of the room measurement I got these confidence levels.

L sub 27

R sub 26

Right 30

Left 33

Is this acceptable?

I must say I ’think" I have an understanding so far and I am up to chapter 12.

But, there are so many confusing graphs and flash forwards, flashbacks.

I have taken deep notes and each time I revisit the settings and notes I understand a little more.