Can you leave class D amps on and not ever turn them off?


Can you leave class D amps on and not ever turn them off?

128x128rvpiano
rvpiano OP
George,
You mention NuForce 8 monoblocks as having gone up in smoke.
Would you suspect the Nuforce 9's as having  the same problem?
Many use the same generic SMP boards from the same manufacturer just different rail volts, so it wouldn't surprise me if they were similar.
See this post of a Nuforce 9se v3 I posted in Stereophile and what it did to a reviewers pair of Wilson Watt Puppy 8's, this wasn't a powersupply issue just the nasty noises the 9se made.
http://www.stereophile.com/comment/561214#comment-561214

Cheers George


Thank you for your reply, George.
I own the original Nuforce 9's and have kept switching them on and off for years.
i guess I'll continue to do so, even though, for a brief period, I left them on and didn't have the annoyance of waiting for them to warm up.

Oh well.....
**Usually** keeping filter caps charged is a good thing for their lifespan. If however that means that the caps also are running warm then its not going to help, especially if some of that warmth comes from ripple current (which tends to be higher at higher frequencies as seen in SMPSs). Careful circuit design can avoid these problems.

As one who has spent a lot of time studying the idea of going off grid and using solar power and the like, one thing that comes up in sorting out how much power you're going to need is how long something is on, and not so much how much power it draws. Class D amps are typically around 85% efficient so a 500 watt amp is going to draw some power even if its just sitting there at idle. Since there is never dead silence even when the preamp is off, that means the output section is engaged even if its not making a lot of power reproducing background noise.

I get that some solid state circuits sound better after they are on for about a day or so. IMO this really says that maybe they aren't all that green compared to tubes if you tend to leave them on all the time so they will sound right.


Interesting thread. I'm using the trigger cables on my Wired 4 Sound mAMPs to power them on/off before/after each listening session. May try leaving them on for 24-hours to see how things go, but that sound pretty great with little to no warm-up time.
I'm running a Rogue Audio Pharaoh integrated. It's a hybrid- tube preamplifier and Class D power amplification. It also has two power switches. The front switch controls the preamplifier. The rear switch (meant to be left on at all times unless changing tubes or configuring the phono section) controls the Class D boards.