Is it a OK to leave tube pre-amps powede up 24/7


I’m relatively new to tubes in my hifi setup. Recently went from SS pre to tube ARC pre-amp and a Croft phono stage.

I have always kept all of my SS gear powered up 24/7(and still do), but I shut down my pre-amp and phono stage now after I am done listening for the day. I power them up at least a half of an hour before I put anything into play.

I would prefer to leave my tube gear on all the time, but am concerned about premature tube wear.

What would the tube folk here think about 24/7?

128x128crazyeddy
Cant's tubes short, and even explode? Is it wise to leave them on if you are not around to leap up and turn the system off?
Well if they're gonna explode I'm not gonna turn 'em on when I'm in the room!!
I have seen a few tubes go out with a bang but never explode.
My TVA-1 used to destroy Mullard Osram KT88s - plate red hot and some sparks then a fizzle and a pop from the speakers!
Folks,

It's not even about tubes, It's about TEMPERATURE and the length of exposure to such temperatures. Speaking of ARC tube preamps YES they run hot! A faulty DC capacitor can cause excessive bias current and destructive heat that can cause PCB go to flames. 

As I've mentioned prior, one is too many, but repaired more than one. Running units 24/7 in simple term mean you don't give your circuit elements a 'recoil' time to recover after applied heat. Shortening life and paying extra for the idle time. That's where simple math shoves all the science behind.
Well, some  ARC tube preamps can power up a pair of small speakers if connected to the output to significant SPL levels.
That is to say that signal tubes there are driven rough almost just like power tubes.
I have a set of adapters to use my preamp with my speakers in case I don't have a power amp to use at the time. The preamp (MP-1) will play my speakers with about the same volume a type 45 SET. But the tubes aren't run that hard and last for years without any degradation of the circuit boards even after decades of use.

What you are saying here suggests that such is a different matter with ARC preamps. But I think if that were really a serious problem we would have heard about it by now! Preamps bursting into flame is a pretty unusual thing and the age of the Internet has been with us for 24 years!! And no such reports. So I think we can regard  this as a 'theoretical' (or perhaps more accurately as a Red Herring) rather than an 'actual' and only applying to certain ARCs, which, if true says more about them than tube preamps in general.

But I do find myself doubtful about this idea- I have friends that work at or have worked at ARC for many years (I live in the same town and knew them before they went to work at ARC) and none of them have reported anything like this (and they would have if they'd heard about it) so I just don't think this is a concern.