Class D Technology

I’ve seen it on the scope, with Nuforce 9se V3, you need to see it for yourself.
Lower or raise the signal level at the same frequency, then increase or decrease the scopes sensitivity to the same visual appearance, and you’ll see the SF noise remains the same. Forest and trees sunshine.

BTW it was this amp that gradually cooked the WP8’s tweeter voice coils, and the owner (a reviewer) was never abusive with high level, if anything he was anal about playing too loud, he now ones Gryphon Antillions, and has not looked back at Class-D.
Maybe in the future when they can rid this SF noise demon totally without any effects down into the audio band, even he concedes to this after what he went through.

Cheers George

I'm not sure what NuForce are doing.  It is possible that they adjust supply voltage to signal level, but that would only mean much lower noise (than for instance Icepower)  at low signal levels.  Noise level at max loudness would be the same as for the amp that doesn't do that (assuming same switching frequency and the filter) - equivalent to about 4mW on 8 ohm speaker.  Icepower doesn't adjust the rails and I'm pretty sure Hypex uses constant supply voltage.   With constant supply voltage amount of switching noise at 90% or 10% duty cycle would be most likely 1/2 or even 1/3 of the one at 50% duty.

Not much doubt that class D noise is independent of signal levels, and poses no unusual threat to speakers.

I own the Spectron monoblocks. Superb sounding amps, amazing value relative to cost.

My advice for anyone on the fence is do your homework, listen and decide for yourself. Only then will you know.

Well Mapman, if you would’ve said this at the beginning of the thread, we could’ve saved a lot of typing.

It’s what I did, and decided class C wasn’t for me.

AFAIK, class C is a poor choice for audio (better for FM transmitter).