Recommendations for top-notch banana speaker cable connectors


I have raised my appreciation of upgraded cabling recently with the addition of Silnote Morpheus II IC's.  I have 10 ga. ohno copper cabling for my 25' speaker runs.  I currently have banana jacks from GLS Audio (formerly Orange County Audio).  Once plugged in, one turns the connector to expand the pin internally, but they still seem to yield a less-than-secure fit and the metal they use is questionable.  

I have handled WBT connectors at audio shows and they are incredibly fine, but at a price that would bust my audio budget.  Furutech seems to have some more affordable connectors with high purity metals.  I am sure that there are banana connectors available that hit a sweet spot between price and performance and would value any insights you lads might willing to provide.  Thanks, Mark

whitestix
Hmm, my audio quest plugs were crimp on.. I'll have to double check which model I bought. I crimped instead of soldering. I lean towards crimping because of the cold weld, which I think is more durable than solder. But really, I doubt it matters, as long as the wire/BFA connection is solid. 
Thumbs down on the inexpensive Dyson BFA's for my Von Damme cable, which is perhaps 10 ga. stranded wire.  At $12, they are cheap enough.  
Dear Tod,
It matters a lot!

AC is very sensitive to soldering. 
If you solder with "multicore" (very strong and hard to cut & melt) the sound differs from the very soft WBT solder.

Durability is just one thing, as contact area is another, but adding a soldering compound to the signal chain, is a thing of big interest.
Unfortunately, in most of cases, you must to choose priorities.

A pure silver plug that is soldered, sounds better than a crimped of lower quality metal.
But then, even this, is dependable upon the rest of materials and the whole philosophy by which the conductors and the insulation is made of.

e.g.1 : Even the highest quality soldering may easily rejected by a cable design of cotton, silk, beeswax, paper, wood, leather, oil, .....
and degrade the cable's signature as seriously as the poorest quality plug, or a shrinking tube at the end (if makes direct contact with the plug or the conductor).

e.g.2 : In a cable design which philosophy has another direction, with active shielding, or passive components inside blocks, PTFE, PVC, foam, epoxy, heavy duty triple wafer spades wrapped on acrylic, .....
 the solder is an essential part, no doubt, no concern, or second thoughts.

You know the importance of the plug at the end and how can change the perceived outcome if it is silver or copper or rhodium or gold plated.
The solder reinforces but hurts the signal flow with impurities.




Hello Randy,

Interconnect:
The unshielded solid core: Physic Harmonic "ECO"
The shielded stranded : Belden 1800F/KLEI Absolute Harmony

Speaker cable:
The solid core : Physic Harmonic "ECO"
The stranded : Duelund DCA-16GA

Power cables:
The solid core : Physic Harmonic "EXTREME"/Iego 8095
The stranded rectangular : Yarbo SP-8000PW/Sonar Quest Gold plated (Aluminum body)

Regards