2. tech-talk
  3. 128479-46

Can't tell,if my house is properly grounded

Hey guys, I have a low level hi/low buzz that is coming through my speakers, not dependent on the integrated tube amps volume. It is amplified when I turn on my Parasound JC3+ Phono preamp, but only slightly. I have the power cords going to the same outlet. I tried running their power through my Furman Elite Power conditioner but that changed nothing. I ran an independent ground wire and checked all the components in various configurations to no avail. I disconnected all the tv cable to make sure it wasn't coming from there and that solved nothing either. I turned off everything in the house I could' no change. I checked my ground outside at the rod and it is all solidly connected, however the depth of the rod is unknown.

any other thoughts before I call out an electrician?
last_lemming
yogiboy's avatar
yogiboy
5,701 posts
 
@last_lemming
Did you try the polarity reverse switch? If not you should give that a shot!
last_lemming OP
639 posts
 
i did try and the polarity reverse to no avail.

I also tried a cheater plug, but since I didn't have one designed for that purpose on hand I used an old extension cord for 2 prong components. It had a little bump out on the end to block the ground prong so a person couldn't "cheat". I cut this prong off and plugged the phono pre into it and promptly blew the fuse. I'm not sure why, maybe when I plugged it in I had the plug reversed?  Not sure.  
fineito
34 posts
 
Also try wrapping your interconnect with aluminum foil.  It worked for my phono noise problem.  You can search and find my prior posts on this solution.
Post removed 
gdhal's avatar
gdhal
1,641 posts
 
i connected the RCA connects to the amp from the phono preamp- NOISE!
That could very easily mean you have a defective RCA cable. Swap the RCA cable with a known good one that is shielded. 
More to discover