Good memory, Chris. This was my post from 4+ (!) years ago:
++++ I have constructed an I beam (balsa wood) that uses a leaf spring from one of the regular ET I beams which allows me to to move the counterweights up to 6 inches from the spindle; although not the 7 inches that I implied. With my cartridges which are either medium compliance Vandenhuls or high compliance MM’s, the improvement in bass weight and detail is significant. One other way to experiment with moving the weight further from the spindle is by using the threaded brass weights on the threaded rod that secures the regular lead weights to the counterweight holder. This allows the weight to be further back, and effectively "extending" the I beam.
Speaking of the I beams, no one has mentioned the importance of experimenting with leaf springs of different compliances. I have three ET (plastic) I beams, each of a different compliance. The lower the compliance the more tightly focused the sound is. Higher compliance springs make the sound a little "bloomier", with an all around easier presentation. ++++
Since adding a pair of REL subs to my system I have revised my findings somewhat since, as has been pointed out, moving the weight back TOO MUCH can cause other problems. On balance, I love what the REL’s are doing for the sound, but with the extended I-beam I find it more difficult to integrate them in a way that sounds natural. I am currently not using it.
So glad to see all the recent activity on this thread. What a great tonearm this is! I never cease to be amazed at the genius behind this design and the fabulously natural sound that it yields. Chris should be commended for his excellent tutorials and advise. A couple of comments on recent discussions:
As was recently pointed out by Chris, as with the setup of a fine musical instrument, it’s all about resonances. With that in mind, I have found that a worthwhile setup detail is making sure that the bolts, adjustment and otherwise, and especially the bolts that secure the two end caps are not too tight which, if too tight, can actually deform the spindle and cause biding at the start and end of its trajectory in the manifold. But beyond that extreme what I am talking about (and I don’t think I am imagining this) is that when all the bolts are tightened "just enough" and with close to equal torque the sound seems to take on even more of that wonderful "this is what live music sounds like" quality that this arm gives like no other in my (limited) experience.
Chris, on a completely unrelated topic: you made me chuckle at the mention of your dog not being allowed downstairs. My beagle/lab shedding machine is not allowed in my studio, nor upstairs where the bedrooms are; although pet hair seems to find its way everywhere, even where the critters are not allowed. After being intrigued by these gizmos and not taking the plunge due to skepticism about whether they would actually work, we finally bought a (now two) robotic vacuums. It is not an exaggeration to say that they have been life changers. This one, which is actually one of the least expensive ones does an amazing job of keeping the floors where the pooch roams clean between full house cleanings, and consequently all other areas and surfaces stay noticeably cleaner as well. It was also a lot of fun watching Artie’s reaction to his new mechanical bud. Highly recommended. Regards.
https://www.amazon.com/gp/product/B01N9P4NH5/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1
