Computer PS Upgrade (Fuse/IEC/Teflon Cap)


Today I successfully installed a PCB fuse holder into my computer’s power supply. The stock fuse had leads soldered to the ends that were then soldered directly to the PCB. It took careful work with the Dremel to widen the PCB inlets to accept the fuse holder and now I can roll fuses with ease. I’ll soon order an SR Black fuse to replace the stock fuse rated at 6.3 amps/250V (5 x 20mm).

The power supply used only 1 film cap and it was rated at 1uf that was replaced with an unused Aura-T teflon cap that was sitting idle on a shelf. The power supply will help burn in the cap. Hopefully, the cap improves the sound of my generic computer which is my main source of music. There are too many teflon caps currently burning in since the acquisition of a Conrad Johnson 150SE; therefore, it will be difficult to distinguish what exactly is attributing improvements or detriments to my system but I cannot complaint at this point because my system sounds good. Today’s soundstage is more holographic than yesterday’s. Let’s see what tomorrow brings.

I noticed that the power supply’s IEC inlet is easily replaceable. It will be replaced by an Oyaide Inlet R that is currently in my modified Running Springs Audio Haley. I plan for the Haley to use the Furutech FI-06 NCF IEC or possibly purchase another Oyaide Inlet R for the computer.

Has anyone else tweaked computer electronics and what was your experience?
c_avila1
The reason why is because the SR Black fuse is an impressive product that improved the sound stage and imaging each time that I added one to my set up. My set up currently uses one in the DAC and two in the amp and it will soon have one in the power supply of my computer. Its worth a try whether or not it sounds good. Experimenting is what makes this "mod-it-yourself" hobby really fun.   
 Experimenting is what makes this "mod-it-yourself" hobby really fun. 
True.
Let us know what you find.
B
Post removed