My Audio Research experience


To all you goners out there, here is my experience with Audio Research.

Approximately four years ago I purchased an AR Reference 75 power amp.  It was on special at the time and I bought if from a dealer in Brisbane, Australia.

I used the amp for the rear channels of my home theatre system which I only use occasionally because I travel a lot for work and I mainly listen to music.

One night I switched the amp on and a white flash and burning smell came from the amplifier and it didn’t power up.  I thought it may have been a tube, and because I had no spares, I reported the problem to my Brisbane dealer and via email to Audio Research.  A copy of the reply sent from AR on the 5th March 2016 follows:

'Thank you for choosing Audio Research and the REF75. I suspect you had an internal tube arc. The internal tube short can also take out a plate or screen resistor. So just replacing the tube will not fix this problem. The resistors also need to be replaced. You can confirm this by checking the bias for this tube. If the bias reads zero, a resistor is open.  This is an easy repair that our distributor in Australia can do.

The SE update for the REF75 comes with a complete new set of tubes including a new set of KT150s.  This is the only way it is sold. If you so choose, Our Australian distributor can also install this SE upgrade for you while the amp is in for repair.'

I then proceeded to order some more tubes to see if a replacement tube would fix the problem.

I ordered the following tubes:

2 x Electro-Harmonix 6H30Pi Gold with Matched Triodes (Balanced)

4 x KT150 Power Vacuum Tube - [Matching (10+ tubes)]

4 x KT120 Power Vacuum Tubes - [Matching (10+ tubes)]

When they arrived, I tried the new tubes but they didn’t fix the problem as the amplifier failed to switch on.  I then contacted my dealer and freighted the amplifier to Brisbane for repair.  This was done in June of last year.  I included all of the above tubes in the package in case they were needed.  I also would have liked the amp to be upgraded to SE status using the tubes supplied if possible.

In September/October last year I enquired about the status of the repair and before Christmas enquired again. After again emailing AR, I was contacted by the Australian Distributor who told me that the service agent in Brisbane had been trying to get parts for the wrong amplifier and that the amplifier would be transported to Melbourne for repair.  I asked them to get me a price for the upgrade using my tubes.

In January/February of this year, I was contacted by the Australian Distributor and had to supply proof of purchase because there was a dispute over whether the amplifier was in fact under warranty when the fault occurred.  I again asked about getting the upgrade using the supplied tubes which were still with the repair agent in Brisbane.  Eventually I was told that I could have the upgrade using AR tubes only, for the heavily discounted price of $3,000 Australian.  Nothing like gouging your customers!!!!!!  Especially when I could have bought a small car for the original cost of the amplifier in Australia.

I chose to just get the original amplifier repaired under warranty which I was told needed a new main circuit board.  This week my amplifier finally arrived back home after nearly 12 months away for a repair under warranty.  The original tubes have been put in a box with ‘Faulty Old Tubes,’ written on the box.  The tubes I sent with the amplifier have not been returned, and no replacement tubes have been included.

I am amazed that the initial fault destroyed six tubes, so I have asked how the Distributor tested the tubes to determine that they were faulty.  I am now left with an amplifier that doesn’t work and 10 expensive vacuum tubes missing somewhere in Australia.  I am also left with a conundrum, if when I finally get my tubes back and use them to ensure the amplifier works, what happens if it doesn’t.  Will AR then blame me for any fault that occurs on power up because I haven’t purchased tubes from them at their heavily marked up prices????

For me I will never touch another Audio Research product for as long as I reside on this planet.  I will be telling all my audiophile friends and putting this report on every forum that will publish it.  Best of luck for the future Audio Research and may you drown in your policy mess!!!

128x128thazeldean
So just to be clear -  you now have a working amp (with the SE upgrade?) and the dealer has returned you the "non ARC" tubes you purchased?


" ARC have been good since I have updated them on the situation but the Australian Distributor is trying to pass the blame back to them advising me that the person at ARC who replied to my original email no longer works there so there was unavoidable discontinuity by ARC. "

I am not siding with Synergy Audio but they weren’t not lying or making up an excuse as Kalvin Dahl, the customer service lead at ARC left in Oct of last year. He quit because he didn’t like their new system for logging customer issues.

http://www.audioaficionado.org/showthread.php?t=38183

Having said that, there should be no excuse for Synergy keeping your amp since November for repair. It should have been turned around within a month or so.

Also there should be no issue using tubes not purchased from ARC, they should work fine as long as they have been tested and matched properly.
AR did NOT say they would do the upgrade with your supplied tubes. To draw an analogy to automotive repair, reach your own conclusion that they should is YOUR problem, not theirs.
SE is ARC transition to KT150.  The SE upgrade includes a complete set of ARC tubes and I believe a fresh warranty.   Another words, you can't get the upgrade without the tubes. 

Also warranty is not transferable so don't understand why you believe it's a warranty repair since it's used? 

Your initial problem sounds like replacing 2 or 3 $5 resistors so don't understand how it escalated to replacing board.

OP doesn't understand how the amps works, company policies ... I suggests do some homework before your next purchase so you don't blame the company for your ignorance.
 According to my information, your unit is out of warranty and was damaged by corrosion caused most likely by a fluid being spilled onto the main board.
Since the unit is USED, is it possible previous ownerS spilled fluid in the amp?
Don't have any experience with ARC power amps but have been using an ARC LS2 MKII B remote preamp for getting close to 30 years.  I audition stuff from time to time but it beats back all pretenders to the crown including recently an LS17-SE and an LS27. As long as I can keep Siemens and Halske 6922 Cca's in it it's a world beater,  but one day the it's time will come.