2. analog
  3. 129346-1783

Phono amp as good as Shindo Aurieges phono section

I have recently , while having my Shindo Aurieges worked on, installed a Tortuga LDR in place of the Shindo. I am surprised that I like the Tortuga a lot. I want to get a Phono amp, at least equivalent to the Aurieges, so I can compare them when the Aurieges is back, and I am missing my analog fix.

I have a Allnic A1500, 300b amp, so the logical choice , to me, is the Allnic 1201. Any recommendations or thoughts appreciated!

 I have an Acoustic Signature table ,with a Trans- Fi tonearm.
acman3
acman3 OP
4,274 posts
 
jperry, I had forgotten about Leben. Thanks, that is defiantly a contender.
I will look into that.








fjn04
1,561 posts
 
An interesting scenario may be to have an Aesthetix Rhea on hand when you get your Aurieges back. You would get two very different perspectives with the Rhea design having no Step up device. That's very uncommon for a tube based phono stage. I can only think of a few companies that do not use Step ups.... Manley, Atmasphere, and Tempo Electric are the others that come to mind. I believe a Rhea is $4500 retail.
acman3 OP
4,274 posts
 

That is an interesting idea. I will have to look into the Rhea, and read some reviews.


What about a RCM Sensor 2? Anyone know anything about that Phono amp?

lewm
13,252 posts
 
Alma-sphere often gets overlooked in these discussions, I think because their products are full function preamplifiers, which actually should be an added value.  The MP3 might fall within your budget.
almarg's avatar
Ag insider logo xs@2x
almarg
9,670 posts
 
Acman3, I'd be careful about impedance compatibility when choosing a phono stage having a tube output stage for use in conjunction with the Tortuga LDR.  It appears that depending on how the LDR is configured and on the attenuation value it is set to its input impedance may be in the 10K to 20K area, which will be too low to be optimal for use with many tube-based phono stages.

For example, Stereophile measured the unbalanced output impedance of the Rhea at 20 Hz as being 3.05K, which would certainly be high enough to be a concern in conjunction with a 10K load.  And I would have suggested that you consider the Herron VTPH-2 that I use, but I don't think it would perform at its best with that kind of load impedance either.

Good luck.  Regards,
-- Al
 
More to discover