I have a blown driver and I'm not sure what to do


I have a set of Paradigm Speakers that make up my 7.1 set-up.  I had blown driver in one of the ADP 590s I'm using for a side speaker and replaced a driver in it ($300) 

I hear distortion in the other ADP and I'm pretty sure it's ANOTHER blown driver.  The price of the driver has gone up to $500.....same exact part.

Part ID # 2030800007 

I don't know that it's worth it....

Any thoughts?

128x128shweinhold

My thoughts should first be targeted towards amplification.

Please check DC(using conventional DC voltmeter or DMM) when system at idle on the speaker terminals or buy woofers in bulk for your 7.1 system 2 per each speaker just in case. After checking DC at idle, I would check with 1khz/.5Vrms input signal to check DC on the output. That requires either signal generator or Serato LP or any record/CD with test signals.

Meanwhile, don't keep your system on at idle and turn off



$500 for a driver, it better be one of the best in the world.  I can't believe paradigm is charging that much. It's not right for their customers and plain pretentious.
Thanks for the responses!

When the first driver went I did consider my amp, and determined that it wasn’t this issue based on discussion with friends and Paradigm.

Denon AVR3808CI

Maybe I missed something, but it’s been the same amp and speakers for over 8 years now. Maybe something is wrong with the amp?

Here’s the rest of my set-up:
Mains
Studio 60 v4
Center
Studio CC 590 v4
Surrounds
Studio ADP 590 v4
Rear
SA-15R-30
Sub
Sunfire True Sub


130W sounds like a lot, but it's not. So if you play loud you might be
distorting (over driving) the very small power supplies in the amp.
Low power = heat= blown speakers

Do you think the amp isn't enough?  It was recommended by several people and I've had no issues for years.

These are only surround speakers, so they really haven't been used much.