2. speakers
  3. 129775-98260

I have a blown driver and I'm not sure what to do

I have a set of Paradigm Speakers that make up my 7.1 set-up.  I had blown driver in one of the ADP 590s I'm using for a side speaker and replaced a driver in it ($300) 

I hear distortion in the other ADP and I'm pretty sure it's ANOTHER blown driver.  The price of the driver has gone up to $500.....same exact part.

Part ID # 2030800007 

I don't know that it's worth it....

Any thoughts?

128x128shweinhold
czarivey
5,946 posts
 

When I hear Denon AVRXXX, I freak out. They're unpredictable, unmanageable, and unserviceable and may reveal LOTS of intermittent problems.

They throw an array of intermittent problems within the time of usage and do not match specified parameters. As previous posters noted, use this AVR only at moderate to low volume levels and do not try to reach IMAX SPL. Also make sure that your speakers do NOT go bellow 6Ohms (which isn't probably the case with your paradigms, but who knows...) or your AVR will be history shortly after blown woofers. The output amp modules are not designed to drive heavy speakers even if specified parameters are showing contrary.


shweinhold's avatar
shweinhold OP
14 posts
 
any recommendations for an amp?

The place I bought the speakers suggested that amp, and I had several other friends speak so highly of it.  I'm really surprised...


czarivey
5,946 posts
 

Well,

Are you willing to go separates or just replace receiver?

I like Carver/Sunfire amplification and would aim for either receiver similar to Cinema Grand or Ultimate Receiver or TGA/TGP combination.

Sell your Denon till it has warranty and value, because they turn to $50 scrap junk very fast. TGA/TGP will always hold value with minimal depreciation.

shweinhold's avatar
shweinhold OP
14 posts
 
When you say separate, do you mean drive the mains with one amp and the others with another?

I'm open to suggestions....I hardly use this anymore, except to watch movies. 

I would probably move the Denon to another room with cheaper speakers and look for a one amp solution, unless you have a strong recommendation.  

I could also use another amp for the mains and use the Denon just for the surrounds?

Scott

shweinhold's avatar
shweinhold OP
14 posts
 
I had a lengthy discussion with a tech at Paradigm and they echoed much of what you're saying here.

I moved, and re-did the speaker configuration using Audessy in my new home.  The crossover was set to 80 mhz, but the speaker size was set to small.  I can't see much more detail than that, but I wonder if that's why it would under-drive the speaker.

Anyway, they recommended the Anthem amplifiers.

Do any of you know them?   

Thanks for your input!

Scott

More to discover