Lafolia: Congrats for your Model 8. I also had that amp with my Avatars and really, you are cooking with gas !!!!.
Don't bother too much with the spkr wire setup, just ask your dealer to work for you a tri-wire config (three pairs of wire for the speaker side and 1 pair for the amp side) and you are set!!.
A simple version would be to just work for a single-wire at both ends and place the cardas wire bridges between the rest of the terminals at the speaker side. This wires should come with your Ascents.
At the amp side, you can run either balanced (XLR) or unbalanced (RCA) cables to your amp. My experience is that you wont find any sonic differences unless all your audio chain is balanced (mean: CDP or table). You wont place any damage to your system if cables are setup correctly, but on a doubt, ask your favourite audio dealer to install it for you at a cost. It will take less than an hour and a hundred bucks or so.
Hope this helps
Fernando
Don't bother too much with the spkr wire setup, just ask your dealer to work for you a tri-wire config (three pairs of wire for the speaker side and 1 pair for the amp side) and you are set!!.
A simple version would be to just work for a single-wire at both ends and place the cardas wire bridges between the rest of the terminals at the speaker side. This wires should come with your Ascents.
At the amp side, you can run either balanced (XLR) or unbalanced (RCA) cables to your amp. My experience is that you wont find any sonic differences unless all your audio chain is balanced (mean: CDP or table). You wont place any damage to your system if cables are setup correctly, but on a doubt, ask your favourite audio dealer to install it for you at a cost. It will take less than an hour and a hundred bucks or so.
Hope this helps
Fernando